Using the Power Switch Cover
WARNING:
If an accident occurs with the power switch cover attached, unplug the power
cord immediately. Continued use may cause fire or shock.
The enclosed power switch cover ensures that the power switch is not pressed
accidentally. To use this cover, install it as shown in illustration B.
Attaching and Removing the Connector Cover
These instructions apply if a connector cover is packed with your printer to
protect your cables. To attach it, follow the steps below:
1.
First, connect all the cables. The connector cover has three possible cable exits:
on the right, left, and back.
2.
Position the two hooks on the connector cover so that they hook the printer
case, as shown in illustration C.
3.
Push the connector cover down to click onto the printer case.
To remove the connector cover, turn the printer over, and push the connector
cover down while pushing both sides of the connector cover inward to detach the
hooks from the printer case. See illustration D.
Installing Roll Paper
1.
Press the button to open the cover. See illustration E.
2.
Remove the used roll paper core, and insert the roll paper. See illustration F.
3.
The correct direction of the paper is shown in illustration G.
Pull out some paper, as shown in illustration H. Close the cover, and tear off
4.
the paper, as shown in illustration I.
Troubleshooting
No lights on the control panel
Check the power supply cable connections and the power outlet.
ERROR LED on (not flashing) with no printing
If PAPER OUT is on, the roll paper is not installed or is near the end.
If PAPER OUT is off, the printer cover is not closed properly.
ERROR LED flashing with no printing (and no paper jam)
Printing stops if the head overheats and resumes automatically when it cools.
If overheating is not the cause, turn the printer off, and after 10 seconds, back on.
Removing Jammed Paper
CAUTION:
Do not touch the thermal head because it can be very hot after printing.
1.
Turn the printer off and press the cover open button.
2.
Remove jammed paper, reinstall the roll, and close the cover.
3.
If paper is caught in the cutter and you cannot open the printer cover, open
the cutter cover as shown in illustration J.
TM-T88IV User's Manual 5
English
Drukuj stronę