Epson C11C456021 - Stylus Photo 960 Color Inkjet Printer Podręcznik użytkownika - Strona 5
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Oprogramowanie Epson C11C456021 - Stylus Photo 960 Color Inkjet Printer. Epson C11C456021 - Stylus Photo 960 Color Inkjet Printer 11 stron. User manual (p.i.m plug-in)
Również dla Epson C11C456021 - Stylus Photo 960 Color Inkjet Printer: Specyfikacje (2 strony), Zacznij tutaj (2 strony), Podręcznik użytkownika (12 strony)
Drukuj stronę
Make sure you have a new ink cartridge before you begin.
Once you start replacing a cartridge, you must complete all
the steps in one session.
1. Make sure the printer is turned on and not printing. (The
green P power light should be on, but not flashing.) Then
open the printer cover.
2. Press and release the H ink button. The print head moves to
the left, and the cartridge that needs to be replaced stops
under the _ ink out mark.
Ink out
mark
3. Press and release the H ink button again.
❏ If more than one ink cartridge is empty, the next
cartridge moves under the _ ink out mark. This
happens after you press the H ink button for every ink
cartridge that needs to be replaced.
❏ If all the empty cartridges have been identified, the print
head moves to the ink cartridge replacement position.
4. Open the cartridge cover.
5. Press in the tab on the back end of the empty cartridge to
unlock it. Then squeeze both tabs, lift the cartridge out of
the printer, and dispose of it carefully.
Warning: If ink gets on your hands, wash them thoroughly
with soap and water. If ink gets into your eyes, flush them
immediately with water.
6. Remove the new cartridge from its package.
Caution: Don't touch the green circuit board on the back of
the cartridge; you may inhibit normal operation and printing.
7. Slide the new cartridge into its slot. The side with the green
circuit board goes in the back of the slot.
8. Press the cartridge down until it clicks into place.
9. If you need to replace any other ink cartridges, repeat steps
5 through 8. Then close the cartridge cover.
10. Close the printer cover and press the H ink button. The
printer moves the print head and begins charging the ink
delivery system.
The lights flash and the printer makes noise. Charging takes
about one minute. When it's finished, the P power light
stops flashing and stays on.
Caution: Never turn off the printer while the Ppower light
is flashing, unless the printer hasn't moved or made noise
for more than 5 minutes.
Printing on Special Media
Select the
Media Type
For this paper name...
Plain paper and envelopes
EPSON Premium Bright White Paper
EPSON Iron-On Transfer Paper
EPSON Photo Quality Ink Jet Paper
EPSON Photo Quality Ink Jet Cards
EPSON Photo Quality Self Adhesive
Sheets
EPSON Matte Paper Heavyweight
EPSON Double-Sided Matte Paper
EPSON Photo Paper
EPSON Panoramic Photo Paper
EPSON Glossy Photo Paper (including roll
paper)
EPSON Photo Quality Glossy Paper
EPSON Glossy Photo Greeting Cards
10/02
EPSON Stylus Photo 960
setting according to these guidelines:
Select this Media Type
setting
Plain paper
360 dpi Ink Jet Paper
Photo Quality Ink Jet Paper
Matte Paper - Heavyweight
Photo Paper
Glossy Photo Paper
EPSON Stylus Photo 960
5
-