Toshiba 24S Series Instrukcja instalacji - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Klimatyzator Toshiba 24S Series. Toshiba 24S Series 10 stron. Air conditioner (split type)
Drukuj stronęINSTALLATION DIAGRAM OF INDOOR AND OUTDOOR UNITS
3
5
Batteries
Filter
2
Wireless remote control
Remark :
Detail of accessory and installation
•
parts can see in the accessory sheet.
Some pictures might be different from
•
the actual parts.
18 Class
Optional Installation Parts
Part
Parts name
code
Refrigerant piping
Liquid side : ∅6.35 mm
A
Gas side
: ∅1.70 mm (18 Class)
: ∅15.88 mm (4 Class)
Pipe insulating material
B
(polyethylene foam, 8 mm thick)
Putty, PVC tapes
C
6
Filter
8
Pan head wood
4
Remote control holder
screw
Vinyl tape
Apply after carrying
out a drainage test.
Extension
drain hose
(Not available,
provided by installer)
24 Class
Secure the outdoor unit with fixing bolts and nuts if the unit is likely to be exposed
•
to a strong wind.
Q'ty
Use ∅8 mm or ∅10 mm anchor bolts and nuts.
•
If it is necessary to drain the defrost water, attach drain nipple 9 and cap water
•
proof ! to the bottom plate of the outdoor unit before installing it.
One
each
1
One
each
For the rear left and left piping
Hook
1
Installation
plate
Insert the cushion between the
indoor unit and wall, and tilt the
indoor unit for better operation.
Do not allow the drain hose to get
slack.
Shield pipe
Make sure to run the drain hose
sloped downward.
The auxiliary piping can be
connected to the left, rear left, rear
right, right, bottom right or bottom
left.
Right
Rear right
Bottom right
Saddle
Insulate the refrigerant pipes
Extension
separately with insulation, not
drain hose
together.
(Not available,
provided by installer)
Fixing bolt arrangement of outdoor unit
108 mm
125 mm
28 mm
Air inlet
Air outlet
600 mm
Toshiba 1110651160 (EN)
Wall
Cut the piping
hole sloped
slightly.
Rear
Left
left
Bottom left
8 mm thick heat resisting
polyethylene foam
90 mm
Drain outlet