Dimplex BF392SD Instrukcja serwisowa - Strona 13
Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Kominek wewnętrzny Dimplex BF392SD. Dimplex BF392SD 13 stron. Built in 2 sided fireplace
Również dla Dimplex BF392SD: Instrukcja instalacji (4 strony), Instrukcja obsługi (12 strony), Instrukcja rozwiązywania problemów (4 strony), Instrukcja obsługi (14 strony)
Drukuj stronę
PROBLEM
Heater
Heater is not turning off
Heater is not turning on
Heater is turning off after a
couple of minutes of operation
Heater emits an odor
Heater fan turns on but heater
lacks heat
Heating element is glowing red
Heater fan runs continuously
Noise
Excessive noise with the heater
on
Grinding or excessive noise with
the heater off
CAUSE
Improper operation
Defective 3-Position Heater Switch
Defective Remote Control Receiver
Improper operation
Loose wiring
Defective 3-Position Heater Switch
Defective Heater Assembly
Build up of dirt/dust in heater assembly
Defective Heater Assembly
Normal Operation
Defective Heater Assembly
Improper operation
Loose wiring
Defective Heater Assembly
Normal Operation
Defective heater assembly
Loose wiring
Defective 3-Position Heater Switch
Defective heater assembly
Dirty Heater Assembly
Defective Heater Assembly
Moving flicker rod hitting or rubbing
against internal components
Defective flicker motor
SOLUTION
Refer to Operation Section
Replace 3-Position Heater Switch
Replace Remote Control Receiver. Initialize to Re-
mote Control.
Refer to Operation Section
Check wiring connections
Replace 3-Position Heater Switch
Replace Heater Assembly
Ensure that exterior intake louvers and firebox cavity
are free of dirt/dust.
Replace Heater Assembly
Normal operation is when the heater emits an odor
for a brief period after the heater is initially turned on.
The heater is burning off any dust accumulated during
manufacturing or operation.
Replace Heater Assembly
Refer to Operation Section
Trace wiring in unit
Replace Heater Assembly
Small glowing sections of the element are considered
normal.
If larger glowing sections are causing the heater to trip
the thermal cutout, unplug unit, discontinue use and
replace heater assembly.
Trace wiring in unit
Replace 3-Position Heater Switch
Replace heater assembly
Ensure that exterior intake louvers and firebox cavity
are free of dirt/dust.
Replace Heater Assembly
Ensure rod is straight and mounted properly in the
bracket, spinning freely away from other components.
Replace if necessary.
Replace flicker motor
13