Dimplex BFSL33 Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kominek wewnętrzny Dimplex BFSL33. Dimplex BFSL33 14 stron. Fireplace
Również dla Dimplex BFSL33: Instrukcja serwisowa (19 strony), Instrukcja obsługi (13 strony), Instrukcja instalacji (19 strony)
Drukuj stronę
Operation
Figure 2
ON
Button
OFF
Button
Plastic
Strip
Battery
Cover
Remote Control Initialization/
Reprogramming
If the remote Control or remote
Control receiver has been
replaced, follow these steps to
initialize the remote Control and
receiver:
1.
Ensure that power is supplied
through main service panel.
2.
Access the manual controls,
(remove the glass doors if
applicable) pull the right hand
steel curtain to the outside of
the unit.
3.
Locate manual controls.
(Figure 1)
4.
set the 3-Position switch to
"Remote" (Figure 1D)
8
5.
Activate the on/off switch,
the red Level 1 Indicator Light
will flash. (Figure 1A)
6.
Press and hold the On button
on the manual controls
(Figure 1B) for five (5)
seconds. The Level 1
Indicator Light (Figure 1E) will
then flash for 10 seconds.
7.
Within
the 10 seconds press
the on button located on the
remote control. (Figure 2)
This will synchronize the remote
control and receiver.
Remote Control Usage
The remote control operates the
fireplace levels sequentially (from
off): flames only; to flames and
low heat; to flames and high heat.
The level is increased every time
the ON button is pressed on the
remote control and the fireplace
can be turned off at any point by
pressing the oFF button.
Battery Replacement
To replace the battery:
1.
slide battery cover open on
the remote control (Figure 2).
2.
Install one (1) 12-Volt (A23)
battery in the battery holder.
3.
Close the battery cover.
www.dimplex.com