ECKey EK6 series Instrukcja instalacji i obsługi - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla System bezpieczeństwa ECKey EK6 series. ECKey EK6 series 15 stron. Internal/external mounting – red and green led control from access control system
Również dla ECKey EK6 series: Podręcznik instalatora (9 strony)
Drukuj stronę11.
Common ECKey Status Light Patterns
Note: The status lights on the EK6 can be controlled by an access control system via the purple wire. If
you are using this wiring option in your installation, be aware that the below table may not be accurate
regarding the status light colors.
STATUS LIGHT
Off
Red
Red Flashing
Green
Green Flashing
Yellow
Blue
Single Flash to Off
Single Flash to Red
Single Flash to Yellow
Double Flashes
Triple Flashes
Quadruple Flashes
Eight Flashes
Solid Momentarily
Solid for 3 Seconds
Solid for 5 Seconds
Purple
ECKey Installation and Operation Guide
DESCRIPTION
Not operating, check power supply
Lock or closed and searching for phones (normal operating mode)
Time allocated for closing
Unlocked or open
Time allocated for opening
Passage/Administrative mode. ECKey is not searching for phones,
but can be connected over Bluetooth for administration
ECKey requesting PIN from phone
ECKey available to be discovered by phones for pairing
ECKey requesting Manager PIN
Phone has been paired and is now a Hidden device
ECKey available to be discovered for administration
Pending delete of all phones
Pending factory reset
Sending Wiegand message (EK6 only). Solid blue for 3 seconds, or until
success/failure response is received from access control system
Pairing is successful
Confirmation of previous action
Factory upgrade was successful. Remove and reissue power to return to
normal operating state
14