Epson PowerLite 765c Instrukcja obsługi - Strona 18

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Oprogramowanie Epson PowerLite 765c. Epson PowerLite 765c 26 stron. Release of check tool for network projectors v1.00 for windows
Również dla Epson PowerLite 765c: Podręcznik użytkownika (42 strony), Instrukcja obsługi (36 strony), Instrukcja obsługi (47 strony), Lista części (1 strony), Biuletyn wsparcia produktu (30 strony), Szybka konfiguracja (2 strony), Instrukcja instalacji (19 strony), Podręcznik użytkownika (1 strony), Podręcznik funkcji (5 strony), Biuletyn wsparcia produktu (25 strony), Biuletyn wsparcia produktu (38 strony), Biuletyn wsparcia produktu (12 strony), Biuletyn wsparcia produktu (42 strony), Biuletyn wsparcia produktu (22 strony), Biuletyn wsparcia produktu (28 strony), Biuletyn wsparcia produktu (41 strony), Biuletyn wsparcia produktu (34 strony), Biuletyn wsparcia produktu (38 strony), Biuletyn wsparcia produktu (28 strony), Biuletyn wsparcia produktu (15 strony), Biuletyn wsparcia produktu (22 strony), Szybka konfiguracja (2 strony)

Drukuj stronę

Epson PowerLite 755c/765c Projector

3. Click

Use IP connect mode

screen:

4. Click

. You see this screen:

IP connection

5. Enter the projector's IP address and click

The IP address is shown in the Projector list and a

searching icon appears.

This icon appears if the search fails

to find the projector

Epson PowerLite 755c/765c Projector

, then click

. You see this

Click here

Enter the IP

address and

click Search

If the search fails to find a projector with the specified IP

address, the searching icon turns into a question mark.

If this happens, run EasyMP to check the projector's IP

address, then repeat this step.

Note:

If you still don't see the projector, make sure the Internet

connection firewall is disabled.

6. Click the projector you want to connect to, then click the

button. If more than one projector is listed, you

Connect

can select additional projectors and connect to them at the

same time.

7. If you are prompted for a keyword, enter the four-digit

number displayed on the EasyMP Network screen and

click

The computer's image is transmitted to the projector and

appears on the screen.

Removing the Wireless 802.11G/B Card

Follow these steps to remove the card from your projector:

1. If you're running NS Connection, click

control bar.

2. Check the card access light to make sure it isn't flashing.

Caution:

Never remove the card while the card access light is green or

flashing. You may damage the card or lose data.

3. Press the eject button. The button pops out.

Eject button

Access light

4. Press the eject button again. The wireless card partially

ejects.

5. Pull the card straight out. Then press the eject button back

in to prevent it from being damaged.

8/05

on the

Disconnect

Click here