Toshiba 22EL833B Digital Series Instrukcja obsługi - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla TV Toshiba 22EL833B Digital Series. Toshiba 22EL833B Digital Series 44 stron. Digital series

Drukuj stronę

Before switching on the television put your decoder and media recorder to Standby if they are connected

and ensure the aerial is connected to your television. To set up the television use the buttons on the remote

IMPORTANT: Ensure that the aerial or cable is

connected and a Common Interface module is not

inserted before switching on the TV for the ﬁ rst time

installation.

Connect the mains plug and switch the TV into

on using the side standby switch. If the TV does

not switch on, press any numbered or standby

button on the remote control, then the language

selection menu will be displayed. This screen will

appear the ﬁ rst time that the television is switched

on and each time the television is reset.

By pressing the

Up or Down buttons highlight the

language you want to set and press OK button.

The following message will be displayed next:

By pressing

Left or Right button, select the

country you want to set and press Down button

to highlight Teletext Language option. Use

Left or Right button to select desired Teletext

Language.

Press

Down button after setting Teletext Language

option. Scan Encrypted will be then highlighted.

You can set Scan Encrypted as Yes if you want

to scan coded stations.

Press

OK button on the remote control to continue

and the following message will be displayed on

the screen:

A01_MB60_[GB]_(IB_INTERNET)_DVB-TC_(CT90326)_10071224_10071226.indd 14

Initial Installation

control as detailed on page 8.

Select

press OK to continue. Afterwards, the following

OSD will be displayed on the screen (*):

If you select

will be displayed (*) :

You can select frequency ranges from this

screen. For highlighting lines you see, use Up or

Down button. You can enter the frequency range

manually by using the numeric buttons on the

remote control. Set Start and Stop Frequency as

desired by using numeric buttons on the remote

control. After this operation, you can set Search

Step as 8000 kHz or 1000 kHz. If you select 1000

kHz, the TV will perform search process in a

detailed way. Searching duration will thus increase

accordingly. (*) When ﬁ nished, press OK button

to start automatic search.

If you select

screen, the television will search for broadcasts.

- 14 -

Yes by using Left or Right buttons and

Cable option, the following screen

Aerial option from the Search Type

02.06.2011 20:56:05