Epson RB-V11H255020-N - PowerLite 83c LCD Projector Podręcznik z informacjami o produkcie - Strona 13

Przeglądaj online lub pobierz pdf Podręcznik z informacjami o produkcie dla Oprogramowanie Epson RB-V11H255020-N - PowerLite 83c LCD Projector. Epson RB-V11H255020-N - PowerLite 83c LCD Projector 16 stron. Warranty statement
Również dla Epson RB-V11H255020-N - PowerLite 83c LCD Projector: Podręcznik użytkownika (42 strony), Instrukcja obsługi (36 strony), Instrukcja obsługi (47 strony), Podręcznik szybkiej konfiguracji (7 strony), Podręcznik funkcji (5 strony), Biuletyn wsparcia produktu (5 strony), Lista części (1 strony), Deklaracja zgodności (4 strony)

5. Use the screwdriver to loosen the two screws holding the

lamp in place. (You can't remove the screws.)

6. Hold the lamp as shown and pull it straight out.

Note:

The lamp(s) in this product contain mercury. Please

consult your state and local regulations regarding disposal or

recycling. Do not put in the trash.

7. Gently insert the new lamp along the guide rail. If it doesn't

fit easily, make sure it's facing the correct way. Push the

lamp down firmly where the label

Caution:

Do not touch the glass portion of the lamp assembly. Touching

the glass could result in premature lamp failure.

Don't remove

these screws

appears.

PUSH

3/08

PowerLite 822p/83c Projector

8. Once the lamp is fully inserted, tighten its screws.

9. Lower the lamp cover into place. (The opening should be

almost covered, and the top of the cover should be flush

with the top of the projector.) Then slide the cover closed

and tighten the screw.

Note:

Be sure to seat the lamp fully and secure the lamp cover. If the

lamp is not properly installed or the cover is loose, the lamp will

not turn on.

10. Reset the lamp timer as described in the next section.

Resetting the Lamp Timer

You must reset the lamp timer after replacing the lamp to clear

the

warning message. Follow the steps

Replace the Lamp

below.

Note:

Do not reset the lamp timer if you have not replaced the lamp. If

you do, the Lamp Hours will not accurately reflect the number of

hours that the lamp has been used.

1. Connect the power cable and turn on the projector.

PowerLite 822p/83c Projector