MSI Codex B913 Podręcznik - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik dla Pulpit MSI Codex B913. MSI Codex B913 38 stron.
Również dla MSI Codex B913: Podręcznik (48 strony)

CE Conformity

Hereby, Micro-Star International CO�, LTD declares that this device is

in compliance with the essential safety requirements and other relevant

provisions set out in the European Directive�

FCC-B Radio Frequency Interference

Statement

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules�

These limits are designed to provide reasonable protection against

harmful interference in a residential installation� This equipment generates, uses and

can radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications� However,

there is no guarantee that interference will not occur in a particular installation� If this

equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the measures listed below:

￭

viii

￭

Notice 1

The changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment�

Notice 2

Shielded interface cables and AC power cord, if any, must be used in order to comply

with the emission limits�

This device complies with Part 15 of the FCC Rules� Operation is subject to the following

two conditions:

1� this device may not cause harmful interference, and

2� this device must accept any interference received, including interference that may

cause undesired operation�

Under the European Union ("EU") Directive on Waste Electrical and

Electronic Equipment, Directive 2002/96/EC, which takes effect on August

13, 2005, products of "electrical and electronic equipment" cannot be

discarded as municipal waste anymore and manufacturers of covered

electronic equipment will be obligated to take back such products at the end of their

useful life�

Downloaded from

ManualsNet.com

Reorient or relocate the receiving antenna�

Increase the separation between the equipment and receiver�

Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected�

Consult the dealer or an experienced radio/television technician for help�

search engine