Philips X Line 49BDL2005X/96 Podręcznik użytkownika - Strona 43
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Monitor Philips X Line 49BDL2005X/96. Philips X Line 49BDL2005X/96 49 stron.
Drukuj stronę
49BDL2005X
8.4.
Dark Dot Defects
Black dot defects appear as pixels or sub-pixels that are always dark or "off". These are the examples of black dot defects:
One dark dot
8.5.
Proximity of Pixel Defects
Because pixel and sub-pixels defects of the same type that are nearby one another may be more noticeable, Philips also
specifies tolerances for the proximity of pixel defects. In the table below you can find specifications about:
•
Allowed amount of adjacent dark dots = (adjacent dark dots =1 pair of dark dots)
•
Minimum distance between dark dots
•
Total no. of all defective dots
8.6.
Pixel Defect Tolerances
In order to qualify for repair due to pixel defects during the warranty period, a PDP / TFT panel in a Philips Plasma / LCD-
display must have pixel or sub-pixel defects exceeding the tolerances listed in the following table.
BRIGHT DOT EFFECT
1 lit sub pixel
BLACK DOT EFFECT
1 dark sub pixel
TOTAL DOT DEFECTS OF ALL TYPES
NOTE: * 1 or 2 adjacent sub pixel defects = 1 dot defect
8.7.
MURA
Dark spots or patches may occasionally appear on some liquid crystal display (LCD) panels. This is known within the industry
as Mura, which is a Japanese term for "unevenness." It is used to describe an irregular pattern or area in which uneven screen
uniformity appears under certain conditions. Mura is a result of the deterioration of the liquid crystal alignment layer and is most
commonly caused by long-term operation under high ambient temperatures. It is an industry- wide phenomenon and Mura is
not repairable. It is also not covered by our warranty terms.
Mura has been around since the introduction of LCD technology and with screens getting bigger and in operation 24/7, many
displays are running in low light conditions. This all adds to the possibility of Mura affecting displays.
HOW TO SPOT MURA
There are many symptoms of Mura and also multiple causes. Several of these are listed below:
•
Impurities or foreign particles in the crystal matrix
•
Uneven distribution of LCD matrix during manufacturing
•
Non-uniform luminance distribution of the backlight
•
Panel assembly induced stress
•
Flaws within the LCD cells
•
Thermal induced stress - high temperature operation over long periods of time
Two adjacent dark dots = 1 pair of dark
dots
32
Two dark dots, specifications defines
the minimum distance between dark
dots
ACCEPTABLE LEVEL
2
ACCEPTABLE LEVEL
10
12