Philips X-Line 55BDL3105X Podręcznik użytkownika - Strona 21

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Monitor Philips X-Line 55BDL3105X. Philips X-Line 55BDL3105X 50 stron. Videowall display

55BDL3105X_55BDL3107X

2.3.3. Inserting the batteries in the remote control

The remote control is powered by two 1.5V AAA batteries.

To install or replace batteries:

1. Press and then slide the cover to open it.

2. Insert batteries with the correct polarity (+) and (-).

3. Replace the cover.

Caution:

Incorrect use of batteries may cause leakage or explosion. Be sure to follow the instructions below:

•

Insert "AAA" batteries with the correct polarity (+ and -).

•

Do not mix battery types.

•

Do not use a new battery with a used one together. Otherwise, it may cause leakage or shorten the life of the batteries.

•

Remove the dead batteries immediately to avoid battery leakage in the battery compartment. Do not touch exposed battery

acid, as it may cause injury to your skin.

NOTE: Remove the batteries from the battery compartment when not using for an extended period of time.

•

Do not drop or apply shock to the remote control.

•

Do not allow any liquid to get inside the remote control. If water has entered the remote control, wipe the remote control

with a dry cloth immediately.

•

Do not place the remote control near heat and steam sources.

•

Do not attempt to disassemble the remote control, unless you need to place batteries in the remote control.

Pointing the remote control at the remote sensor on the display.

Use the remote control within 5 m from the sensor on the display at an

angle of 20 degrees from the left and right.

NOTE:

•

The remote control may not function properly when the remote control

sensor on the display is under direct sunlight or strong illumination, or

when an obstacle blocks the signal transmission.

•

Use an IR sensor cable for better performance of the remote control.

(Refer to 3.5. IR connection for details)

20°