MSI Wind Box DC100 Podręcznik użytkownika - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Pulpit MSI Wind Box DC100. MSI Wind Box DC100 50 stron. Wind box dc100 personal computer

Preface

CE Conformity

Hereby, Micro-Star International CO., LTD declares that this de-

vice is in compliance with the essential safety requirements and

other relevant provisions set out in the European Directive.

FCC-B Radio Frequency Interference

Statement

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential instal-

lation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instruction

manual, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment oﬀ and on, the user is encouraged to

try to correct the interference by one or more of the measures listed below:

￭

viii

￭

Notice 1

The changes or modiﬁ cations not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

Notice 2

Shielded interface cables and AC power cord, if any, must be used in order to

comply with the emission limits.

VOIR LA NOTICE D'INSTALLATION AVANT DE RACCORDER AU RESEAU.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

this device may not cause harmful interference, and

this device must accept any interference received, including interference that

may cause undesired operation.

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit diﬀ erent from that to

which the receiver is connected.

Consult the dealer or an experienced radio/television technician for

help.