Philips 3 DISC SHELF STSYEM W60 FWC3C37 Podręcznik użytkownika - Strona 7

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla System stereo Philips 3 DISC SHELF STSYEM W60 FWC3C37. Philips 3 DISC SHELF STSYEM W60 FWC3C37 28 stron. Philips mini hi-fi systems brochure

Drukuj stronę

GENERAL INFORMATION

General Information

• The typeplate (which contains

the serial number) is located at

the rear of the system.

• Recording is permissible if

parties are not infringed.

• This device complies with the

Federal Communications

Commission (FCC) rules, part 15

and with 21 CFR 1040.10.

Operation is subject to the

following two conditions:

– This device may not cause

harmful interference, and

– This device must accept any

interference received, including

interference that may cause

undesired operation.

Environmental

Information

All unnecessary packaging has been

omitted. We have tried to make the

packaging easy to separate into three

materials: cardboard (box), polystyrene

foam (buffer) and polyethylene (bags,

protective foam sheet).

pg 01-28/C3-35-30/37-Eng 1

Your system consists of materials which

can be recycled and reused if

disassembled by a specialized company.

Please observe the local regulations

regarding the disposal of packaging

materials, exhausted batteries and old

equipment.

Accessories

(Supplied)

– Remote control

– Batteries (two AA size) for remote

control

– AM loop antenna

– FM wire antenna

– AC power cord

– SS39 Surround Speakers

(for model FWC3 & C35 only)

SAFETY INFORMATION

Safety Information

• Before operating the system, check

that the operating voltage indicated

on the typeplate (or the voltage

indication beside the voltage

selector) of your system is identical

with the voltage of your local power

supply. If not, please consult your

dealer. The typeplate is located at the

rear of your system.

• When the system is switched on, do

not move it around.

• Place the system on a solid base (e.g.

a cabinet).

• Place the system in a location with

adequate ventilation to prevent

internal heat build-up in your system.

Allow at least 10cm (4 inches)

clearance from the rear and the top

of the unit and 5cm (2 inches) from

each side.

• Do not expose the system to

excessive moisture, rain, sand or heat

sources.

12/14/99, 9:48 AM

• Under no circumstances should you

repair the system yourself, as this will

invalidate the warranty!

• If the system is brought directly from

a cold to a warm location, or is

placed in a very damp room,

moisture may condense on the lens

of the CD unit inside the system.

Should this occur, the CD player will

not operate normally. Leave the

power on for about one hour with

no disc in the system until normal

playback is possible.

• Electrostatic discharge may cause

unexpected problems. See whether

these problems disappear if you

unplug the AC power cord and plug

it in again after a few seconds.

• To disconnect the system from

the power supply completely,

remove the AC power plug

from the wall socket.

CLASS 1

LASER PRODUCT

3139 116 19372 (ENG)