Toshiba TDP-MT500 Instrukcja obsługi - Strona 35
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Projektor Toshiba TDP-MT500. Toshiba TDP-MT500 40 stron. Home projector
Również dla Toshiba TDP-MT500: Instrukcja obsługi (42 strony)
Drukuj stronę
(b)
Handle
(a)
POWER button
{ button
} button
•
If the lamp-used-hours have exceeded 1500 hours and the lamp has been replaced, it is not possible to turn on the new
light-source lamp until the lamp-used-hours are reset.
•
Do not reset the lamp-used-hours if the lamp is not replaced.
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering Projector Lamp, give following information to dealer.
•
Replacement Lamp Type No; TLPLMT50
Disposal of Used Lamp
The lamp of this product uses a small amount of inorganic mercury harmful to environment. Handle the used lamp
with care not to break it, and dispose it separately as one of harmful waste goods like fluorescent lamp and the
similar. And in a self-government where separate waste goods collection is conducted, dispose the lamp according
to its ordinance.
Cleaning dust in the intake vent
If dust is accumulated in the intake vent, the temperature in the projector
goes up abnormally, and may damage the internal parts. Also, the light-
source lamp may come off to protect the internal parts. Clean up the dust
with a vacuum cleaner about once a year.
Cleaning the projector
Softly wipe off dirt on the projector with a soft cloth.
•
If the dirt is thick, wipe it off with a cloth soaked in a neutral detergent diluted with water, and then finish with a dry cloth.
•
If any pesticide is sprayed over the projector, or if the projector is wiped with benzine or thinner, or if rubber or
vinyl products are brought into contact with the projector for a long period of time, the paint on the projector
could be damaged.
Cleaning the lens
Remove dust or dirt on the lens with a commercially available lens cleaning kit (blower, brush, and the like).
•
Because the surface of the lens is easily scratched, do not rub or hit the surface with anything hard.
REPLACING THE LAMP / CLEANING THE PROJECTOR
7 Holding the handle, pull out the light-source lamp
from the projector.
•
Pull out the light-source lamp slowly. The lamp may burst the
glass of the lamp is pulled out too quickly.
•
Do not spray water over the light-source lamp and do not put
it where children can reach it or near anything flammable. It
may cause burn or injury.
8 Holding the handle of a new lamp, insert the lamp
to main the shape of the hole in the projector.
9 Press the handle into the storage.
•
Make sure that the handle is securely locked.
10 Securely screw down the three fixing screws (b)
with the Phillips screwdriver.
11 Insert the lamp cover into the projector, and se-
curely screw down the screw (a) with the Phillips
screwdriver to fix the lamp cover.
•
If the lamp cover is dislocated, the power can not be turned on.
12 Connect the power cord and turn on the power.
13 Simultaneously press on the {
POWER button ( ) on the operation panel for more
than 3 seconds.
•
If the three buttons are not pressed simultaneously, the lamp-used-
hours may not be reset. If you do not this, the projector unit
will not count the lamp hours for your next replacement.
{
{
}
}
{
{ , }
}
} buttons and
Exhaust vent
Intake vent
35