Philips FW P88 Podręcznik użytkownika - Strona 24

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla System stereo Philips FW P88. Philips FW P88 31 stron. Mini hi-fi system with 3 cd changer
Również dla Philips FW P88: Podręcznik użytkownika (30 strony), Podręcznik użytkownika (31 strony), Specyfikacje (2 strony), Specyfikacje (2 strony), Podręcznik (32 strony), Podręcznik (31 strony)

Drukuj stronę

TAPE

3a(for playback on tape deck 2 only)

• Press í or ë to select tape side (see

Tape Side) .

• Press A. REV to select the different type

of playback mode (see Auto Reverse

Playback) .

4 Press Ç to end playback.

™ "T1 or T2" with "! ! ! or @ @ @"

will be displayed.

Note:

– When the tape has stopped playing, the

system will switch to standby mode

after 30 minutes if no button is pressed.

Rewind/Fast Forward

When playback is stopped

1 You can rewind or fast forward the tape

by pressing à or á respectively.

™ If rewinding, "T1 ! or T2 !" with

"!" scrolling left will be displayed.

™ If fast forwarding, "T1 @ or

T2 @" with "@" scrolling right will be

displayed

™ The tape will stop automatically at

the end of the rewinding or fast

forwarding.

2 Press Ç to stop rewinding or fast

forwarding.

pg 01-31/P88/22-Eng

During playback

• Press and hold à or á until the

desired passage is located.

™ "T1 or T2" with "! ! or @ @"

scrolling left or right will be

displayed depending on which button

is pressed.

™ During searching, the sound is

reduced to a low volume.

™ When you release à or á, the

tape continues playing.

Notes:

– During rewinding or fast forwarding of a

tape, it is also possible to select another

source (e.g. CD, TUNER, or AUX).

– Before playing a tape, check and tighten

slack tape with a pencil. Slack tape may

get jammed or may burst in the

mechanism.

– C-120 tape is extremely thin and is

easily deformed or damaged. It is not

recommended for use in this system.

– Store the tapes at room temperature

and do not put them too close to a

magnetic field (for example, a

transformer, TV, or speaker).

Dolby B Noise Reduction

System

1 Press DOLBY B NR to switch on Dolby

B NR.

™ The d B NR appears in the display.

2 Press DOLBY B NR again to switch off

Dolby B NR.

™ The d B NR disappears from the

display.

Note:

– A tape recorded with the Dolby B NR

system should also be played in the

Dolby B NR mode. If you forget to

operate the DOLBY B NR button, the

treble may be reproduced too strongly.

3/6/00, 1:27 PM

3139 116 19721