Croydex STICK 'N' LOCK PREMIUM Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Armatura łazienkowa Croydex STICK 'N' LOCK PREMIUM. Croydex STICK 'N' LOCK PREMIUM 2 stron. Shower rod

Drukuj stronę

SECTION 2 - ASSEMBLY

First, carefully cut the O-rings that are securing the end caps

together. Separate the pressure plate (1) from the decorative cap

(2). Then slide one wall bracket (3) over each end of the rod with

the red backing tape facing the end of the rod. Then position

both of the O-rings in the recesses of the end caps (4).

(See Fig. 1A, 1B & 1C)

fig. 1A

fig. 1C

SECTION 3 - INSTALLATION

IMPORTANT INFORMATION!

must

The rod

be installed straight and level

must not

The rod

be installed across grout lines

must

Wall surfaces

meet the criteria outlined in 'Safety &

Product Care' notes 1, 10 & 11.

fig. 2A

fig. 2B

Tension fit the rod into place.

TWIST TO UNLOCK

fig. 3A

fig. 3B

EXTEND TO THE WALLS

WARNING!

YOU MUST TIGHTEN THE ROD UNTIL

IT CANNOT BE TIGHTENED ANY

FURTHER.

in the rod not being secured fully.

fig. 1B

(See Fig. 2A).

(See Fig. 2B).

(See front page).

(See Fig. 3A, 3B & 3C)

Smaller diameter tube

TWIST TO LOCK

fig. 3C

Failure to do this will result

PEEL OFF

the red backing from both brackets, cut the

backing tape and remove without disturbing the rod. Press the

brackets firmly to the wall at both ends. Avoid grout lines.

(See Fig. 4A & 4B)

fig. 4A

fig. 4B

Ensure the pins on the end cap (1) align with the slots (2)

in the pressure plate, locate the pressure plates over the self-

adhesive wall brackets and rotate to apply force. Repeat this

for both ends of the shower rod.

DO NOT OVER TIGHTEN!

(See Fig. 5A, 5B & 5C)

fig. 5A

fig. 5B

Slide the decorative caps over both pressure plates and

snap into place.

(See Fig. 6)

IMPORTANT! YOU MUST WAIT 24 HOURS BEFORE

APPLYING ANY WEIGHT TO THE ROD!

adhesive tape to cure and reach it's full bond strength.

fig. 6

24 HOURS

When installing your shower curtain rings. Install them

over the smaller section of the tension rod, this will be easier

than installing over the larger diameter section and will reduce

the risk of damaging the surface finish of the rod.

Your shower curtain & rod are now ready for use!

fig. 5C

This will allow the

R&R 079 R02