Cruiser Sup V-Max AIR 12'6" Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria Cruiser Sup V-Max AIR 12'6". Cruiser Sup V-Max AIR 12'6" 8 stron.

using the screw to guide it. Align the nut with the hole in the front of the fin and

tighten the finger screw into place. Once you cannot slide the fin forward or

backwards it is secure and ready.

Deflating Your Stand Up Paddle Board

Untwist the valve cap and make sure to clear away any water or debris. Push

the center pin in to initiate deflation. Be warned, a burst of air will come out

very quickly and may frighten you but this is normal and will calm down

quickly. Once the air has slowed down from the initial burst twist the center pin

in a clockwise motion until it stays in the "down" position. The board will now

deflate without having to hold the pin in.

Folding Up Your

Stand Up Paddle Board

Once you have the center pin of the valve in the "down"

position and air is able to deflate without holding pin in you

may start to fold you board. Start at the nose end of the

board to push the air towards the valve and out. Fold the

board over itself in roughly

1 foot segments until you

reach the tail and all of the air

has been released. Use the

provided clip strap to wrap

around the board for easier

carrying. Place the folded

board along with all of the

provided accessories into the

travel bag and you are all set

to go.

Installing the Fin

It is easiest to install the center fin when your board is

deflated. Simply fold the tail end of the board over so that

the fin box is showing completely. Slide the base of the fin

into the track (see picture) and position to the back of the

box. Brand new fin boxes are often a bit tight and may

require a "see-saw" motion to properly insert the fin. En-

sure that you are lining the two pins on either side of the

base of the fin up with the track inside of the fin box. After

a few uses, the fin box will be much easier to insert and

remove the fin. Take the finger screw (no tools necessary)

and unscrew from the front

of the fin. Insert the square

nut into the other end of the

fin track and push forward