3Com 3C877 Skrócona instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Modem 3Com 3C877. 3Com 3C877 16 stron. Impact isdn external digital modem

Phone #2 (if required by the telephone company)

SPID #2 (if required by the telephone company)

Each of these items is stored in special S registers within the

digital modem. These S registers are set by issuing ATSxx=

commands to the digital modem. The 3Com Impact digital

modem software will automatically issue the AT commands

to set the S registers as part of the conﬁguration process.

The following three sections describe how to conﬁgure the

3Com Impact digital modem using the Windows, DOS, or

Macintosh operating systems, respectively.

After you conﬁgure the digital modem and verify that it is

working properly, you should install the TurboCom software.

Refer to the installation instructions that came with the

TurboCom software. This software is required only for

IBM PC or compatible computers running Windows 3.X.

Conﬁguration for IBM PC or Compatible Computer

You can conﬁgure the 3Com Impact digital modem for

an IBM PC or compatible using either the Windows-based

installation program or the MS-DOS

Conﬁguration Using Windows

To conﬁgure the digital modem for an IBM PC or compatible

computer using Windows:

1 Insert the 3Com Impact DOS & Windows Installation

Diagnostic Utilities diskette into an available diskette drive.

2 Select Run from the File menu. In the Run dialog box, type:

a:setup

The check box labeled Run Minimized should be left

unchecked.

3 Click OK.

The installation process begins copying the conﬁguration

program to the hard disk. A message box provides the status

of the installation and indicates when it is complete.

Configuring the 3Com Impact Digital Modem

–based installation program.