Aeon Labs Aeotec Smart Switch 7 Skrócona instrukcja obsługi - Strona 2
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Przełącznik Aeon Labs Aeotec Smart Switch 7. Aeon Labs Aeotec Smart Switch 7 9 stron.
Drukuj stronę
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or
may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage
resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only
for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a
fire or near open heat sources.
What is Z-Wave?
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use
in the region mentioned in the Quickstart section.
Z-Wave ensures a reliable communication by reconfirming every
message (two-way communication) and every mains powered
node can act as a repeater for other nodes (meshed network) in
case the receiver is not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be used
together with any other certified Z-Wave device regardless of
brand and origin as long as both are suited for the same
frequency range.
If a device supports secure communication it will communicate
with other devices secure as long as this device provides the same or a higher level of security. Otherwise it will
automatically turn into a lower level of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
Product Description
The Aeotec Smart Switch 7 is an elegant appearance, small size, easy to use, Smart Plug. This supports power
metering function, with high measurement accuracy, and more accurate knowledge of the power consumption of
the load, over-current, over-load and over-heat protection, which is more secure and reliable, scene
personalization and is more intelligent, Night Light Mode to reduce light pollution, S2 Security, which is safer
and more reliable and SmartStart, making inclusion more convenient.
Prepare for Installation / Reset
Please read the user manual before installing the product.
In order to include (add) a Z-Wave device to a network it must be in factory default state. Please make sure to
reset the device into factory default. You can do this by performing an Exclusion operation as described below in
the manual. Every Z-Wave controller is able to perform this operation however it is recommended to use the
primary controller of the previous network to make sure the very device is excluded properly from this network.
Reset to factory default
This device also allows to be reset without any involvement of a Z-Wave controller. This procedure should only
be used when the primary controller is inoperable.
If not, plug it into a wall socket and power on. To complete the reset process manually, press and hold the Action
Button for at least 15s and then release. The LED indicator will become breathing blue light, which indicates the
reset operation is successful. Otherwise, please try again.