Aeon Labs Aeotec MULTISENSOR 6 Podręcznik użytkownika - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria Aeon Labs Aeotec MULTISENSOR 6. Aeon Labs Aeotec MULTISENSOR 6 11 stron.
Również dla Aeon Labs Aeotec MULTISENSOR 6: Podręcznik (14 strony)

Aeon Labs Aeotec MULTISENSOR 6 Podręcznik użytkownika
2/26/2018
1. Take your Minimote to your MultiSensor.
2. Press the Remove Button on your Minimote.
3. Press the Action Button on your MultiSensor .
4. If your MultiSensor has been successfully removed from your network, the RGB LED will be active with a colourful gradient for 3
seconds. When you press the Action Button on MultiSensor, its green LED will blink. If the removal was unsuccessful, the green
LED will stay solid for a few seconds when you press the Action Button.
5. Press any button on your Minimote to take it out of removal mode.
If you're using an existing gateway (ie. Vera, Smartthings, ISY994i ZW, Fibaro, etc):
You may need to refer to your gateway's method of including devices if you do not know how to pair a Z-Wave device. You may use any
gateway to perform an unpair/removal on Multisensor 6 even if they are not paired together to factory reset Multisensor 6.
1. Put your primary Z-Wave gateway into unpair mode, your Z-Wave gateway should confirm that it is waiting to remove a device
2. Press the Action Button on your MultiSensor. The LED on Multisensor will blink red then change into a colourful gradient.
3. If your MultiSensor has been successfully removed from your network, the RGB LED will be active with a colourful gradient for 3
seconds. When you press the Action Button on MultiSensor, its green LED will blink. If the removal was unsuccessful, the green
LED will stay solid for a few seconds when you press the Action Button.
Monitoring motion.
MultiSensor can send Basic Set Command to association group 1, which is setup via the Association Command Class, when Motion
Sensor detects movement to control the associated devices to "OPEN" state. After 4 minutes by default, if the Motion Sensor is not
triggered again, MultiSensor will send Basic Set Command to these devices to set them to their "CLOSE" state. However, if Motion
Sensor is triggered again within 4 minutes, MultiSensor will reset the timing and start timing again.
Waking up Multisensor 6.
In order to configure Multisensor 6, you must either (1) wake up Multisensor 6 using the below button press function, or (2) temporarily
put your Multisensor 6 on USB power.
1. Press and hold Multisensor 6 Action button
2. Wait until the RGB LED turns into a Yellow/Orange Color
3. Release Multisensor 6 Action Button
https://aeotec.freshdesk.com/support/solutions/articles/6000057073-multisensor-6-user-guide-
MultiSensor 6 user guide. : Aeotec by Aeon Labs
9/11