Dimplex RITZ Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Grzałka elektryczna Dimplex RITZ. Dimplex RITZ 4 stron.
Drukuj stronę
Remote
control - see Fig. 3
The maximum range of use is ~ 5 metres.
Warning: It takes time for the receiver to respond to the transmitter.
Do not press the buttons more than once within two seconds for
correct operation.
Battery information - see Fig. 3
1. To activate the remote control remove the battery isolation strip,
which is used to ensure your remote control reaches you fully charged.
2. To replace the remote control battery, turn over the remote control,
and follow the diagram embossed on the remote control
3. Only use CR2025 size of batteries.
Discard leaking batteries
Dispose of batteries in the proper manner according to provincial
and local regulations.
Any battery may leak electrolyte if mixed with a different battery
type, if inserted incorrectly, if all the batteries are not replaced at the
same time, if disposed of in a fire, or if an attempt is made to charge
a battery not intended to be recharged.
WARNING - KEEP BATTERIES OUT OF REACH OF CHILDREN
1. Swallowing may lead to serious injury in as little as 2 hours or death,
due to the chemical burns and potential perforation of the oesophagus.
2. If you suspect your child has swallowed or inserted a button battery
immediately call the 24-hour Poisons Inforation Centre on 13 11 26 (in
Australia) or 0800 764 766 (in New Zealand) for fast, expert advice.
3. Examine devices and make sure the battery compartment is
correctly secured, e.g. that the screw or other mechanical fastener
is tightened. Do not use if the compartment is not secure.
4. Dispose of used button batteries immediately and safely. flat
batteries can still be dangerous.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE ATTEMPTING ANY MAINTENANCE.
Glen Dimplex Australia
8 Lakeview Drive,Scoresby,
VIC 3179,
Australia
www.dimplex.com.au
Ph: 1300 556 816
This product is protected by Intellectual property rights and patents owned by the Glen Dimplex Group on an international basis. The Glen Dim-
plex Group of Companies will actively protect these rights.
c
Glen Dimplex.
All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing from Glen
Dimplex.
Light Emitting Diode
This fire is fitted with LED (Light Emitting Diode) lamps. These LED
lamps are maintenance-free and should not require replacing during
the life of the product.
Thermal Safety Cut-out
The built-in overheat cut-out switches off the appliance automatically in
the event of a fault. If this occurs switch off the appliance or disconnect
the mains plug from the socket. After a short cooling down phase, the
appliance is ready for use again. If the fault should occur again, see
your local dealer.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY
BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use abrasive
cleaners. The glass viewing screen should be cleaned carefully with a
soft cloth. DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or fluff the soft brush attachment of
a vacuum cleaner should occasionally be used to clean the outlet grille
of the fan heater.
Recycling
At the end of the electrical products useful life it should not
be disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or retailer for
recycling advice in your country.
After Sales Service
Please see the separate Warranty leaflet for details of your
Warranty & After Sales Service including contact details.
Should you require after sales information or assistance with this
product, please contact Glen Dimplex Australia on 1300 556 816
(AUS) / 09 274 8265 (NZ) or visit our website at www.dimplex.
com.au (AUS) / www.dimplex.co.nz
(NZ).
Glen Dimplex Australasia Ltd.
38 Harris Road,
East Tamaki,
Auckland 2013
New Zealand
www.dimplex.co.nz
Ph: +61 9 274 8265