Dimplex XLS12N Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Grzałka elektryczna Dimplex XLS12N. Dimplex XLS12N 8 stron. Ultra-slim storage heaters
Również dla Dimplex XLS12N: Instrukcja obsługi (10 strony), Instrukcja obsługi (4 strony), Instrukcja instalacji (8 strony), Instrukcja obsługi (4 strony), Instrukcja instalacji (8 strony)

10. Remove wall fixing bracket from heater by removing

the screws at each end.

11. Mark wall bracket fixing positions and screw wall bracket

to wall following closely the guidelines in steps 12 and 13.

NOTE: It is essential that two of the fixing points are the

lower short fixing slots at each end of the wall bracket.

12. Solid Brick/High Density Block Walls. (See step 13 if

walls are low density block.) These must be drilled and

plugged with the Rawlplug No. 10 size fibre inserts

provided. The correct size of drill (5.5mm) should be used

and the hole should be drilled to a depth of 6mm greater

that the length of the Rawlplug so that the fixing is made

below the plaster layer.

13. Low Density Block Walls. A specialised fixing, such

as the Unifix LB70, should be employed following closely

the manufacturer's instructions.

Panelled Internal Walls. Here it is best to locate the

studding and use No. 10 size woodscrews. Where it is not

possible to locate the studding use type M5 Rawlplug

INTERSETS on securely fastened plasterboard panelling.

For other wall panel materials the wall panel manufacturer

should be consulted for details of suitable wall fixing

devices.