Aeon Labs Aeotec Siren Gen5 ZW080 Instalacja i specyfikacja - Strona 3
Przeglądaj online lub pobierz pdf Instalacja i specyfikacja dla System bezpieczeństwa Aeon Labs Aeotec Siren Gen5 ZW080. Aeon Labs Aeotec Siren Gen5 ZW080 7 stron.
Drukuj stronęPairing your Siren Gen5 into your existing Z-Wave network.
1. Place your gateway or controller into Z-Wave pair or inclusion mode. (Please
refer to your controller/gateway manual on how to do this)
2. Press the Action Button on your Siren Gen5, and its LED will blink rapidly to
indicate that it is communicating.
3. If your Siren has been successfully linked to your network, its LED will become
solid for 2 seconds, the stop. If linking was unsuccessful, the LED will blink when
you tap its button.
With your Siren now working as a part of your smart home, you'll be able to configure
it from your home control software. Please refer to your software's user guide for
precise instructions on configuring Siren to your needs.
You're able to test your Siren's speaker system manually. Please note that the
speaker system is 106dB and very loud – we recommend only testing your Siren
while wearing the necessary ear protection given you'll need to be next to your Siren
while manually testing it. To manually test Siren, press and hold the Action Button for
5 seconds.
Advanced.
Removing your Siren from a Z-Wave network.
Your Siren can be removed from your Z-Wave network at any time. It is always
advised that you use your gateway to perform an unpair in order to avoid leaving
phantom / failed nodes that become difficult to remove. To do so, follow the steps
below:
Unpairing your Siren Gen5 from your existing Z-Wave network.
1. Place your gateway or controller into Z-Wave unpair or exclusion mode. (Please
refer to your controller/gateway manual on how to do this)
2. Press the Action Button on your Siren.
3. If your Siren has been successfully unlinked to your network, its LED will begin
to blink.