Pioneer DEH-2590UI Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik samochodowy Pioneer DEH-2590UI. Pioneer DEH-2590UI 21 stron. Cd rds receiver

Drukuj stronę

Installation

j When using a subwoofer of 70 W (2 W), be

sure to connect the subwoofer to the violet

and violet/black leads of this unit. Do not

connect anything to the green and green/

black leads.

k Not used.

l Subwoofer (4 W) × 2

Notes

! With a 2 speaker system, do not connect any-

thing to the speaker leads that are not con-

nected to speakers.

! Change the initial menu of this unit. Refer to

SP-P/O MODE (rear output and preout set-

ting) on page 11.

The subwoofer output of this unit is monau-

ral.

Power amp (sold separately)

Perform these connections when using the op-

tional amplifier.









1 System remote control

Connect to Blue/white cable.

2 Power amp (sold separately)

3 Connect with RCA cables (sold separately)

4 To Front output

5 Front speaker

6 To Rear output or subwoofer output

7 Rear speaker or subwoofer

Installation

Important

! Check all connections and systems before

final installation.

! Do not use unauthorized parts as this may

cause malfunctions.

! Consult your dealer if installation requires

drilling of holes or other modifications to the

vehicle.

! Do not install this unit where:

— it may interfere with operation of the vehicle.

— it may cause injury to a passenger as a result

of a sudden stop.

! The semiconductor laser will be damaged if

it overheats. Install this unit away from hot

places such as near the heater outlet.

! Optimum performance is obtained when the

unit is installed at an angle of less than 60°.

60°

! When installing, to ensure proper heat dis-

persal when using this unit, make sure you

leave ample space behind the rear panel and

wrap any loose cables so they are not block-

ing the vents.

Leave ample

5 cm

space

5 cm

5cm

DIN front/rear mount

This unit can be properly installed using either

front-mount or rear-mount installation.

Installation

Use commercially available parts when instal-

ling.

DIN Front-mount

Insert the mounting sleeve into the dash-

board.

For installation in shallow spaces, use the sup-

plied mounting sleeve. If there is enough space,

use the mounting sleeve that came with the ve-

hicle.

Secure the mounting sleeve by using a

screwdriver to bend the metal tabs (90°) into

place.

1 Dashboard

2 Mounting sleeve

Install the unit as illustrated.

1 Nut

2 Firewall or metal support

3 Metal strap

4 Screw

5 Screw (M4 × 8)

# Make sure that the unit is installed securely in

place. An unstable installation may cause skipping

or other malfunctions.

DIN Rear-mount

Determine the appropriate position

where the holes on the bracket and the side

of the unit match.

Tighten two screws on each side.

1 Truss screw (5 mm × 8 mm)

2 Mounting bracket

3 Dashboard or console

Removing the unit

Remove the trim ring.

1 Trim ring

2 Notched tab

! Releasing the front panel allows easier ac-

cess to the trim ring.

! When reattaching the trim ring, point the

side with the notched tab down.

Section