Pioneer DEH-4600BT Instrukcja instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Odbiornik samochodowy Pioneer DEH-4600BT. Pioneer DEH-4600BT 33 stron. Cd rds receiver
Również dla Pioneer DEH-4600BT: Instrukcja obsługi (37 strony)

Drukuj stronę

Pioneer DEH-4600BT Instrukcja instalacji

Installation

Install the microphone clip on the sun

visor.

With the sun visor up, install the microphone

clip. (Lowering the sun visor reduces the voice

recognition rate.)

1 Microphone clip

When installing the microphone

on the steering column

Detach the microphone base from the mi-

crophone clip.

To detach the microphone base from the micro-

phone clip, slide the microphone base.

1 Microphone

2 Microphone clip

3 Microphone base

Install the microphone on the steering

column.

1 Double-sided tape

2 Install the microphone on the rear side of the

steering column.

Adjusting the microphone angle

Connections

Important

! When installing this unit in a vehicle without

an ACC (accessory) position on the ignition

switch, failure to connect the red cable to the

terminal that detects operation of the ignition

key may result in battery drain.

ACC position

No ACC position

! Use of this unit in conditions other than the

following could result in fire or malfunction.

— Vehicles with a 12-volt battery and negative

grounding.

— Speakers with 50 W (output value) and 4 W to

8 W (impedance value).

! To prevent a short-circuit, overheating or mal-

function, be sure to follow the directions

below.

— Disconnect the negative terminal of the bat-

tery before installation.

— Secure the wiring with cable clamps or adhe-

sive tape. Wrap adhesive tape around wiring

that comes into contact with metal parts to

protect the wiring.

— Place all cables away from moving parts,

such as the shift lever and seat rails.

— Place all cables away from hot places, such

as near the heater outlet.

— Do not connect the yellow cable to the battery

by passing it through the hole to the engine

compartment.

— Cover any disconnected cable connectors

with insulating tape.

— Do not shorten any cables.

— Never cut the insulation of the power cable of

this unit in order to share the power with

other devices. The current capacity of the

cable is limited.

— Use a fuse of the rating prescribed.

— Never wire the negative speaker cable directly

to ground.

— Never band together negative cables of multi-

ple speakers.

! When this unit is on, control signals are sent

through the blue/white cable. Connect this

cable to the system remote control of an ex-

ternal power amp or the vehicle's auto-anten-

na relay control terminal (max. 300 mA

12 V DC). If the vehicle is equipped with a

glass antenna, connect it to the antenna

booster power supply terminal.

! Never connect the blue/white cable to the

power terminal of an external power amp.

Also, never connect it to the power terminal

of the auto antenna. Doing so may result in

battery drain or a malfunction.

! The black cable is ground. Ground cables for

this unit and other equipment (especially,

high-current products such as power amps)

must be wired separately. If they are not, an

accidental detachment may result in a fire or

malfunction.

This unit

4 5

1 Power cord input

2 Microphone input

3 Microphone (4 m)

4 Rear output or subwoofer output

5 Front output (DEH-X5600BT only)

6 Antenna input

7 Fuse (10 A)

8 Wired remote input

Section