Pioneer DEH-7300BT Instrukcja obsługi - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik samochodowy Pioneer DEH-7300BT. Pioneer DEH-7300BT 23 stron. Cd rds receiver
Również dla Pioneer DEH-7300BT: Instrukcja obsługi (29 strony), Instrukcja instalacji (29 strony)
Drukuj stronę
Section
Installation
03
This unit
3
1
2
4 5
6
7
8
1 Power cord input
2 Microphone input
3 Microphone
4 Rear output or subwoofer output
5 Front output
6 Antenna input
7 Fuse (10 A)
8 Wired remote input
Hard-wired remote control adaptor can be
connected (sold separately).
Power cord
Perform these connections when not connect-
ing a rear speaker lead to a subwoofer.
1
L
2
4
6
8
F
7
9
5
c
R
b
d
e
f
g
h
12
En
Perform these connections when using a sub-
woofer without the optional amplifier.
1
L
2
4
6
F
7
i
b
SW
e
j
f
g
k
h
1 To power cord input
2 Left
3 Right
4 Front speaker
5 Rear speaker
6 White
7 White/black
8 Gray
9 Gray/black
R
a Green
3
b Green/black
c Violet
d Violet/black
e Black (chassis ground)
Connect to a clean, paint-free metal location.
f Yellow
Connect to the constant 12 V supply termi-
nal.
g Red
Connect to terminal controlled by ignition
switch (12 V DC).
h Blue/white
Connect to system control terminal of the
power amp or auto-antenna relay control ter-
minal (max. 300 mA 12 V DC).
i Subwoofer (4 Ω)
Installation
j When using a subwoofer of 70 W (2 Ω), be
sure to connect the subwoofer to the violet
and violet/black leads of this unit. Do not
connect anything to the green and green/
R
black leads.
3
k Not used.
8
l Subwoofer (4 Ω)× 2
9
Notes
! With a 2 speaker system, do not connect any-
c
d
thing to the speaker leads that are not con-
nected to speakers.
! Change the initial setting of this unit. Refer
c
to SW CONTROL (rear output and subwoofer
l
setting) on page 10.
b
d
The subwoofer output of this unit is monau-
ral.
Power amp (sold separately)
Perform these connections when using the op-
tional amplifier.
1
5
1
7
1 System remote control
Connect to Blue/white cable.
2 Power amp (sold separately)
3 Connect with RCA cables (sold separately)
4 To Rear output or subwoofer output
5 Rear speaker or subwoofer
6 To Front output
7 Front speaker
Installation
Important
! Check all connections and systems before
final installation.
! Do not use unauthorized parts as this may
cause malfunctions.
! Consult your dealer if installation requires
drilling of holes or other modifications to the
vehicle.
! Do not install this unit where:
— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result
of a sudden stop.
! The semiconductor laser will be damaged if
it overheats. Install this unit away from hot
places such as near the heater outlet.
! Optimum performance is obtained when the
unit is installed at an angle of less than 60°.
3
2
4
DIN front/rear mount
5
3
This unit can be properly installed using either
front-mount or rear-mount installation.
2
6
Use commercially available parts when instal-
7
ling.
DIN Front-mount
1
Insert the mounting sleeve into the dash-
board.
For installation in shallow spaces, use the sup-
plied mounting sleeve. If there is enough space,
use the mounting sleeve that came with the ve-
hicle.
60°