Pioneer SUPER TUNER III KEH-5252 Instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik samochodowy Pioneer SUPER TUNER III KEH-5252. Pioneer SUPER TUNER III KEH-5252 21 stron. Cassette car stereo with fm/am electronic tuner
Drukuj stronęConnections
Note:
• Be aware that connection Is different between 2-speaker system and
4-speaker system. Failure to follow the wiring diagram may cause consid
erable loss of power even when fader control is at the center position.
• To avoid shorts in the electrical system, be sure to disconnect the battery
© cable before beginning installation.
• Replace fuses only with the types stipulated on the fuse holder.
• Be sure to properly connect the color coded leads. Failure to do so can
cause malfunctions.
• Cover unused terminals with tape to prevent electrical shorts.
• Refer to the power amp owner's manual when connecting a power amp
(sold separately) to the pin jack.
• Since a unique BPTL circuit is employed, never wire so the speaker leads
are directly grounded or the left and right speaker 0 leads are common.
• When a blue lead (system control terminal) is present on the power amp,
connect this lead to the unit's blue lead, and do not connect the unit's red/
white lead to anything. When the power amp does not have a blue lead
(system control terminal), connect the unit's red/white lead to the power
amp red lead.
2-speaker high-power system
Black (ground)
To vehicle (metal) body.
Red
To electric terminal controlled by ignition
switch (12 V DC) ON/OFF.
Orange
To terminal always supplied with power re
gardless of ignition switch position.
Blue
System control/Auto-antenna relay control
terminal (Max. 300 mA 12 V DC).
Red/White
When the power amp (sold separately)
does not have a blue lead (system control
terminal), connect the unit's red/white lead
to the power amp red lead.
Red i
^ Connection cords with
=
I pin plugs (sold separately) t
Antenna jack
White
Black (ground)
Connector
Power amp
(sold separately)
Red/white,
CDO«
I
Fuse holder
Orange
Blue! Blue
Black (ground)
Gray ©
© Green
O Green/black
Gray/black O
No connection in this
type of system.
D
©
©
0
• Set the fader control to the left horizontal position for a 2-speaker high-
power system. When a power amp (sold separately) Is connected to this
system, the fader control cannot be used to control the speaker output of
this unit.