Pioneer Super Tuner IIID AVH-P4100DVD Instrukcja instalacji - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Odbiornik samochodowy Pioneer Super Tuner IIID AVH-P4100DVD. Pioneer Super Tuner IIID AVH-P4100DVD 43 stron. Dvd rds av receiver
Również dla Pioneer Super Tuner IIID AVH-P4100DVD: Broszura (9 strony), Instrukcja instalacji (8 strony), Skrócona instrukcja obsługi (8 strony)

Pioneer Super Tuner IIID AVH-P4100DVD Instrukcja instalacji

Installation

Note
• Check all connections and systems before final
installation.
• Do not use unauthorized parts. The use of
unauthorized parts may cause malfunctions.
• Consult with your dealer if installation requires
drilling of holes or other modifications of the
vehicle.
• Do not install this unit where:
— it may interfere with operation of the vehicle.
— it may cause injury to a passenger as a result
of a sudden stop.
• Do not install the display where it may (i) obstruct
the driver's vision, (ii) impair the performance of
any of the vehicle's operating systems or safety
features, including air bags, hazard lamp buttons
or (iii) impair the driver's ability to safely operate
the vehicle.
• The semiconductor laser will be damaged if it
overheats. Install this unit away from hot places
such as near the heater outlet.
• Optimum performance is obtained when the unit
is installed at an angle of less than 30°.
• To some types of vehicles, this unit cannot be
properly installed. In such case, use the optional
installation kit (ADT-VA133).
14
Installation using the screw
holes on the side of the unit
Fastening the unit to the factory
radio-mounting bracket.
Position the unit so that its screw holes are
aligned with the screw holes of the bracket,
and tighten the screws at 3 or 4 locations on
each side.
Factory radio
mounting bracket
Binding screw or
flush surface screw
Be sure to use the
screws supplied
with this unit.
Note
In some types of vehicles, discrepancy may
occur between the unit and the dashboard. If this
happens, use the supplied frame to fill the gap.
If the pawl gets in the way,
bend it down.
Dashboard or console