Pioneer DEH-1701UB Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik Pioneer DEH-1701UB. Pioneer DEH-1701UB 36 stron. Cd rds receiver

Drukuj stronę

CAUTION

• There is a potential danger of explosion if the battery is incorrectly replaced. When replacing the

battery, replace it with the same type.

• Do not handle or store the battery with metallic tools or objects.

• If the battery leaks, remove the battery and wipe the remote control completely clean. Then install a

new battery.

• When disposing of used batteries, compliance with governmental regulations or environmental

institutions' rules that apply in your country/area must be followed that pertain to any special

handling needed for disposal.

Important

• Do not store the remote control in high temperatures or direct sunlight.

• Do not let the remote control fall onto the floor, where it may become jammed under the brake or

accelerator pedal.

Setup menu

When you turn the ignition switch to ON after installation, [SET UP :YES] appears in the

display.

Press the M.C. dial.

The setup menu disappears after 30 seconds of no operation. If you prefer not to set

at this time, turn the M.C. dial to select [NO], then press to confirm.

Turn the M.C. dial to select the options, then press to confirm.

To proceed to the next menu option, you need to confirm your selection.

Menu Item

Description

LANGUAGE

Select the language to display the text information from a

compressed audio file.

[ENG](English),

[РУС](Russian),

[TUR](Turkish)

CLOCK SET

Set the clock.

FM STEP

Select the FM tuning step from 100 kHz or 50 kHz.

[100], [50]

[QUIT :YES] appears when all the settings have been made.

To return to the first item of the setup menu, turn the M.C. dial to select [QUIT :NO],

then press to confirm.

Press the M.C. dial to confirm the settings.

NOTES

• You can cancel the menu setting by pressing SRC/OFF.

• These settings can be made at any time from the SYSTEM settings (page 9) and INITIAL settings

(page 5).

Canceling the demonstration display (DEMO OFF)

Press the M.C. dial to display the main menu.

Turn the M.C. dial to select [SYSTEM], then press to confirm.

Turn the M.C. dial to select [DEMO OFF], then press to confirm.

Turn the M.C. dial to select [YES], then press to confirm.

INITIAL settings

Press and hold SRC/OFF until the unit turns off.

Press and hold SRC/OFF to display the main menu.

Turn the M.C. dial to select [INITIAL], then press to confirm.

Turn the M.C. dial to select an option, then press to confirm.

Menu Item

Description

FM STEP

Select the FM tuning step from 100 kHz or 50 kHz.

[100], [50]

SP-P/O MODE

Select when there is a full-range speaker connected to the rear

speaker output leads and there is a subwoofer connected to the

[REAR/SUB.W]

RCA output.

[SUB.W/SUB.W]

Select when there is a passive subwoofer connected directly to

the rear speaker output leads and there is a subwoofer

connected to the RCA output.

[REAR/REAR]

Select when there are full-range speakers connected to the rear

speaker output leads and RCA output. If there is a full-range

speaker connected to the rear speaker output leads, and the

RCA output is not used, you may select either [REAR/SUB.W] or

[REAR/REAR].

SYSTEM RESET

Select [YES] to initialize the unit settings. The unit will be

restarted automatically.

[YES], [CANCEL]

(Some of the settings may be retained even after resetting the

unit.)