Pioneer DVH-330UB Instrukcja instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Odbiornik Pioneer DVH-330UB. Pioneer DVH-330UB 33 stron. Dvd rds receiver
Również dla Pioneer DVH-330UB: Instrukcja obsługi (40 strony), Skrócona instrukcja obsługi (8 strony)

Drukuj stronę

Section

Connections

Power cable connection

Note:

Depending on the kind of vehicle, the

function of 2* and 4* may be different. In

this case, be sure to connect 1* to 4*

and 3* to 2*.

Yellow (2*)

Back-up (or

accessory)

Red (4*)

Accessory

(or back-up)

Black (chassis ground)

Connect to a clean, paint-free metal location.

ISO connector

Note:

In some vehicles, the ISO connector

may be divided into two. In this case, be

sure to connect to both connectors.

Connect leads of the same

color to each other.

Fuse (10 A)

Yellow (1*)

Connect to the constant

12 V supply terminal.

Fuse resistor

Red (3*)

Connect to terminal controlled

by ignition switch (12 V DC).

Speaker leads

Front left 

White:

Front left 

White/black:

Front right 

Gray:

Front right 

Gray/black:

Rear left 

Green:

Rear left 

Green/black:

Rear right 

Violet:

Rear right 

Violet/black:

Connections

Wired remote input

Hard-wired remote control adaptor can

be connected (sold separately).

Antenna jack

This product

Yellow/black

If you use an equipment with Mute function, wire

this lead to the Audio Mute lead on that

equipment. If not, keep the Audio Mute lead free

of any connections.

Blue/white

Connect to system control terminal of the

power amp (max. 300 mA 12 V DC).

Blue/white (5*)

The pin position of the ISO connector will

differ depends on the type of vehicle. Connect

5* and 6* when Pin 5 is an antenna control

type. In another type of vehicle, never connect

5* and 6*.

Blue/white (6*)

Connect to auto-antenna relay control

terminal (max. 300 mA 12 V DC).

Section