Pioneer DVH-345UB Instrukcja obsługi - Strona 23
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik Pioneer DVH-345UB. Pioneer DVH-345UB 32 stron.
Drukuj stronę
Installation
# Make sure that the unit is installed securely in
place. An unstable installation may cause skipping
or other malfunctions.
DIN Rear-mount
1
Determine the appropriate position
where the holes on the bracket and the side
of the unit match.
2
Tighten two screws on each side.
3
1
2
1 Truss screw (5 mm × 8 mm)
2 Mounting bracket
3 Dashboard or console
Removing the unit
1
Remove the trim ring.
1 Trim ring
2 Notched tab
! Releasing the front panel allows easier ac-
cess to the trim ring.
! When reattaching the trim ring, point the
side with the notched tab down.
2
Insert the supplied extraction keys into
both sides of the unit until they click into
place.
3
Pull the unit out of the dashboard.
Removing and re-attaching the
front panel
You can remove the front panel to protect your
unit from theft.
Press the detach button and push the front
panel upward and pull it toward you.
For details, refer to Removing the front panel to
protect your unit from theft and Re-attaching the
front panel on page 6.
Additional information
Troubleshooting
Common
Symptom
Cause
The power will not turn on.
Leads and connectors are incor-
The unit will not operate.
rectly connected.
The fuse is blown.
Noise and/or other factors are
causing the built-in microproces-
sor to operate incorrectly.
Operation with the remote
Battery power is low.
control is not possible.
Some operations are prohibited
The unit does not operate cor-
with certain discs.
rectly even when the appropri-
ate remote control buttons
are pressed.
Playback is not possible.
The disc is dirty.
The type of disc loaded cannot be
played on this unit.
The disc loaded is not compatible
with this video system.
There is no sound.
Cables are not connected cor-
The volume level will not rise.
rectly.
The unit is performing still, slow
motion or frame-by-frame play-
back.
The
icon is displayed, and
The operation is prohibited for
operation is not possible.
the disc.
The operation is not compatible
with the configuration of the disc.
The image displayed stops
The data could no longer be read
(pauses) and the unit cannot
during playback.
be operated.
There is no sound.
The volume level is low.
The volume level is low.
The attenuator is on.
Section
04
Action (Reference page)
Confirm once more that all connections
are correct.
Rectify the cause and then replace the
fuse. Be sure to install a fuse with the
same rating.
Turn the unit off and then on. (Page 6)
Load a new battery.
Try operating with another disc.
Clean the disc.
Check the disc type.
Change the disc to one that is compatible
with your video system.
Connect the cables correctly.
There is no sound during still, slow mo-
tion or frame-by-frame playback.
This operation is not possible.
This operation is not possible.
Stop playback once, and start playback
again.
Adjust the volume level.
Turn the attenuator off.
23
En