Pioneer VSX-453 Instrukcja obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik Pioneer VSX-453. Pioneer VSX-453 27 stron. Audio/video stereo receiver
Również dla Pioneer VSX-453: Instrukcja obsługi (29 strony), Instrukcja serwisowa (49 strony)
Drukuj stronę
®
@@@
@
@
/
]
FM/AM
ANTENNA terminals (-._ Page 7)
Connect
to FM and AM antennas.
PHONO input jacks (=1_Page 7)
Connect
to the output
cables
from
a turntable.
CD input jacks (-I_ Page 7)
Connect
to the output
jacks
of a compact
disc player.
(_ GND terminal
(-I_ Page 7)
Connect
the turntable
ground
lead to this terminal.
Loosen
the screw,
connect
the ground
lead,
and then
tighten
the
screw.
LD input
jacks (-I_ Page 8)
Connect
to an LD player's
output
jacks (audio,
video).
® REAR SPEAKERS terminals (-I_ Page 9)
Connect
the rear speakers
to these
terminals.
Use rear speakers
with impedance
of 8 Q--16
Q.
® CENTER SPEAKER terminals (-I, Page 9)
Connect
the center
speaker
to these
terminals.
Use center
speakers
with
impedance
of 8 Q--16
Q.
® CENTER AMP PRE OUT jack (-I_ Page 7)
When
a separate
power
amplifier
is used to drive
the surround
center
speaker,
connect
the power
amplifier
to this jack.
® TAPE 2 MONITOR
jacks (-_ Page 7)
Connect
to audio components
such as a second
cassette
deck or a
graphic
equalizer.
VCR/TAPE
1 jacks (-I_ Pages 7, 8)
Connect
to the first cassette
deck or a VCR. With a VCR, also connect
the video
jacks.
@ VIDEO OUT (TO MONITOR TV) jack (-I_ Page 8)
Connect
to a monitor
IV.
@ MULTI-ROOM REMOTE IN jack (-I, Page 10)
Connect
to the separately
sold MR-100
Multi-Room
remote
sensor
unit.
(_ CONTROL IN/OUT jacks
IN
: Connect
this jack to other Pioneer
components
(main unit or
remote
control
unit)
when
using
those
components
to
control
this
unit.
OUT
: Connect
this jack to other
Pioneer
components
when
using
the
remote
control
of
this
unit
to
control
the
other
components.
NOTE:
The receiver's
remote
sensor
does
not
function
when
a plug
is
inserted
in the lNjack.
To operate,
point
the remote
control
unit at the
remote
sensor
on the component
to which
the receiver's
IN jack
is
connected.
When
using
the MR-100
/ /
/ co. trol
/
umt
....
R e ii_ni_:;
_onea_tk ,_
_mote
T:c tkhef Ct O eNTROLelN
control
unit
component
bearing
the _
mark.
(_ FRONT SPEAKERS terminals (,-_ Page 9)
A: Connect
to the first set of speakers.
B: Connect
to the second
set of speakers.
Use speakers
with
impedance
of 8 Q--16
2.
11
<ARB1466>