Pioneer VSX-RS320-k Instrukcja obsługi - Strona 39

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik Pioneer VSX-RS320-k. Pioneer VSX-RS320-k 44 stron. Audio/video multi-channel receiver

Drukuj stronę

Making recordings

Chapter 8:

Making recordings

Making an audio or a video

recording

You can make an audio or a video recording

from the built-in tuner, or from an audio or

video source connected to the receiver (such

as a CD player or TV).

Keep in mind you can't make a digital

recording from an analog source or vice-versa,

so make sure the components you are

recording to/from are hooked up in the same

way (see Connecting your equipment on

page 13 for more on connections).

If you want to record a video source, you also

need to use the same type of connection for the

source as for the recorder. For example, you

can't record a component hooked up to

composite video jacks with a recorder hooked

up to the component video outputs (see

page 19 for more on video connections).

RECEIVER

INPUT SELECT

ZONE 2

RECEIVER

ON/OFF

BD DVD

CD-R

PORTABLE MULTI IN SIGNAL SEL

PORTABLE

TODOROKI

PHASE S.RETRIEVER

Note

1 The receiver's volume, balance, tone (bass, treble, loudness), and surround effects have no effect on the recorded signal.

SOURCE

TV CONTROL

INPUT

DVR

TUNER

SIGNAL SEL

VOL

Select the source you want to record.

Use the input function buttons or INPUT

SELECT buttons on the remote control, or the

front panel INPUT SELECTOR dial.

Select the input signal (if necessary).

Press SIGNAL SEL to select the analog input

signal corresponding to the source component

(see page 25 for more on this).

Prepare the source you want to record.

Tune to the radio station, load the CD, video,

DVD etc.

Prepare the recorder.

Insert a blank tape, MD, video etc. into the

recording device and set the recording levels.

Refer to the instructions that came with the

recorder if you are unsure how to do this. Most

video recorders set the audio recording level

automatically—check the component's

instruction manual if you're unsure.

Start recording, then start playback of the

source component.