Pioneer VSX-604S Instrukcja obsługi - Strona 32

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik stereo Pioneer VSX-604S. Pioneer VSX-604S 34 stron.

Drukuj stronę
TROUBLESHOOTING
Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component,
check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical
appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER
authorized service center or your dealer to carry out repair work.
Power does not come on
even
when
the POWER
switch is pressed.
Control
is not possible
regardless
of
what
operation button Is pressed.
No sound is produced, even
when the input selector
button is selected.
No picture is produced,
even
when
the
input
selector button is selected.
High noise level.
32
<ARB7022>
* Power cord is disconnected.
* Instances are rare, but the problem may
be due to the operation of the protector
circuit.
+ Static electricity affects the unit when the
air is dry, such as in winter.
* Connections are incorrect.
* The MUTE button is pressed.
* VOLUME is turned down.
- Speaker
connecting
wires
are
disconnected from speaker terminals.
* One or both of the input cords are
disconnected.
* TAPE 2 MONITOR button is in the ON
position.
* Connect cord securely.
* Unplug the power cord of the unit from the
AC wall outlet, then plug it in again.
* Unplug the power cord of the unit from the
AC wall outlet, then plug it in again.
'If static electricity is pronounced,
it is
recommended that you operate the unit using
the remote control unit.
* Consult pages 7-11 and perform connections
correctly.
* Press the MUTE
button
to cancel
the
MUTING effect.
* Raise volume.
* Connect wires to terminals securely.
* Connect input cords securely.
« Press the button again to the OFF position.
* The SPEAKERS button is OFF.
* Switch the SPEAKERS button ON.
* Connections are incorrect.
* The VCR and the selected input selector
button are not correct.
+ Station has not been tuned in to correct
frequency.
r
* Antenna has not been connected or has
become disconnected.
FM reception
* Accessory FM antenna remains bundled
up or it is not pointing in right direction.
* Weak broadcasting station signals
AM reception
* AM loop antenna is not pointing in right
direction.
+ Weak broadcasting station signals.
* Noise is being picked up by this unit from
other equipment (especially electrical
appliances using motors or fluorescent
lights).
* Straighten out the antenna and pointin the
* Replace accessory FM antenna with outdoor
. Change the direction of the AM loop anterma and
* Erect an outdoor AM antenna or connect a
- Turn off the appliances generating nd Se or
* Separate the antenna from the unit bysome
* Consult pages 7-11 and perform connections
correctly.
* Press the correct button.
* Tune the station in correctly.
* Connect the antenna securely.
direction which provides optimum reception.
FM antenna.
find a position where reception is improvecd.
ground wire.
remove them from the vicinity of the stereo
equipment.
distance.