Pioneer VSX-D7025 Instrukcja obsługi - Strona 22

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik stereo Pioneer VSX-D7025. Pioneer VSX-D7025 44 stron.

Drukuj stronę

Press the POWER switch to the ON position.

Select TUNER with the INPUT SELECTOR.

Be sure to turn the TAPE 2 MONITOR button OFF when listening

to AM or FM broadcasts.

Switch ON the SPEAKERS button corresponding to the speakers

being used.

DIRECT ACCESS TUNING

FM auto stereo reception and monaural reception

Each time you press the MPX MODE button, the FM MONO indicator

in the display section lights or goes out.

indicator is out, the STEREO indicator lights, and sound is in stereo.

e lf an FM stereo broadcast is received when the FM MONO

indicator is lit, the sound will be monaural.

If there is interference during STEREO mode reception, switch to

FM MONO. The sound will become monaural but interference will

be reduced.

1. Select either FM or AM using the BAND FM/AM button.

2. Press the DIRECT ACCESS button

3. Input the desired station frequency using the STATION CALL

[eT

ets:

AUTO TUNING

Auto tuning is convenient when you do not remember the frequency

of a desired station, or when you wish to find stations that you do not

normally listen to.

f@cef_-11ittI]ss

1. Use the BAND FM/AM button to choose either FM or AM.

she

4. Adjust the sound volume and tone as desired.

To cancel frequency input

Direct access is canceled when the DIRECT ACCESS button is pressed

again.

Under the following conditions direct access is canceled and the unit

returns to the condition in effect before direct access was selected:

Notes regarding direct access tuning

2. Press the TUNING MODE button and the AUTO TUNING indicator

lights.

3. Press the "+" or "~'' of the TUNING buttons.

® Pressing ''+'' causes scanning to take piace in the direction of

increasing frequency. Pressing ''—'' causes scanning to take place

in the direction of decreasing frequency.

¢ When a station is received, scanning will stop (the

indicator lights). If you wish to receive a different station, press

the TUNING button "+" or "'—"' again.

° Pressing either of the TUNING (—, +) button during auto tuning

causes tuning to stop at the current frequency.

4. Adjust the sound volume and tone as desired.

NOTE:

* When Auto Tuning is used, correct reception may not be possible

for very distant stations or stations with very weak signals. In this

event, Manual Tuning is recommended.

° The [TUNED | indicator may not light with broadcasts received over

long distances, or when the broadcast signals are extremely weak.