Pioneer GM-D1004/XEVUC Instrukcja serwisowa - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Wzmacniacz Pioneer GM-D1004/XEVUC. Pioneer GM-D1004/XEVUC 26 stron. Class d four-channel amplifier

5

1. SERVICE PRECAUTIONS

1.1 SERVICE PRECAUTIONS
1. You should conform to the regulations governing the product (safety, radio and noise, and other regulations),
and should keep the safety during servicing by following the safety instructions described in this manual.
2. The part listed below is difficult to replace as a discrete component part.
When the part listed in the table is defective, replace whole Assy.
Unit
PCB

1.2 NOTES ON SOLDERING

For environmental protection, lead-free solder is used on the printed circuit boards mounted in this unit.
Be sure to use lead-free solder and a soldering iron that can meet specifications for use with lead-free solders for repairs
accompanied by reworking of soldering.
Compared with conventional eutectic solders, lead-free solders have higher melting points, by approximately 40 C.
Therefore, for lead-free soldering, the tip temperature of a soldering iron must be set to around 373 C in general, although
the temperature depends on the heat capacity of the PC board on which reworking is required and the weight of the tip of
the soldering iron.
Compared with eutectic solders, lead-free solders have higher bond strengths but slower wetting times and higher melting
temperatures (hard to melt/easy to harden).
The following lead-free solders are available as service parts:
Parts numbers of lead-free solder:
GYP1006 1.0 in dia.
GYP1007 0.6 in dia.
GYP1008 0.3 in dia.

2. SPECIFICATIONS

2.1 SPECIFICATIONS
For all items except the backup current, refer to the Owner's Manual.
Backup current......................... 1.0 mA or less
5
6
No.
Part No.
IC101
IR4322
IC301
IR4322
GM-D1004/XEVUC
6
7
Reason
Heat pad
Heat pad
7
8
A
B
C
D
E
F
3
8