Pioneer SA-1040 Instrukcja obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Pioneer SA-1040. Pioneer SA-1040 13 stron.
Również dla Pioneer SA-1040: Instrukcja serwisowa (22 strony)
Drukuj stronę
OPERATION
Before starting any operation:
Set the controls and switches on the stereo amplifier as shown in the figure below.
(a After all the other switches and
[4 Set the ADAPTOR/TAPE
2
controls have been set, press the
switch to OFF.
POWER
switch to ON.
@ PIONEER
sterco
ameuren
SA-1040
Dynamic
Power
Non
Switching
LOUONESS
SUBSONIC
(a Press the SPEAKERS switch
id Set the BALANCE control to the [a Rotate the VOLUME control to its
(usually A) that corresponds to
center "0" position.
leftmost ''0'" position.
the speaker terminals to which
the speakers have been con-
nected (A or B).
NOTE:
/n order to protect the speakers, the power muting circulft is
activated immediately after the power has been switched
on and for about 3 seconds no sound is heard.
The unit
Starts to function as soon as the muting circuit is released.
RECORD PLAY
FM/AM
RECEPTION
Press the PHONO function switch.
Press the TUNER function switch.
Operate the turntable and place the record on the
Tune in the station on the tuner.
platter.
Adjust the sound using the VOLUME control.
Start playing the record. Once the platter starts to
Pal Adjust the sound quality to your preference using
rotate and the stylus descends onto the record,
the bass and treble controls.
adjust the unit's volume with the VOLUME
con-
trol.
OPERATION
OF COMPONENT
CON-
For further details, refer to the Operating Instruc-
NECTED
TO
CD/AUX
TERMINALS
tions of the turntable concerned.
[4]
Adjust the sound quality to your preference using
Press the CD/AUX function switch.
the bass and treble controls.
Press the CD/AUX
switch (1 or 2) corresponding
to the component
connected
to the rear panel
auxiliary terminals (CD/AUX 1, 2).
Operate the component and start play.
[4]
Adjust the sound quality to your preference using
the bass and treble controls.