Pioneer VSA-1000 Instrukcja obsługi - Strona 28

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Pioneer VSA-1000. Pioneer VSA-1000 35 stron. Av digital surround amplifier
Również dla Pioneer VSA-1000: Instrukcja obsługi (35 strony)

Drukuj stronę

USE OF LEARNING FUNCTIONS

ueann (*)

TRanewer

use

wineo

RECALL oes LEARN

power

TAPE/VCR

Ce Go

st yanr

EI CI Go Gd oe

T VER CH

@ LEARN indicator

This indicator lights when the Learn function is operating.

LIT:

Learning is possible.

OFF:

Regular remote contro! functions can be performed.

NOTE:

If the LEARN indicator flashes, it indicates that the program capacity

has been exceeded and that the fast command has not been properly

memorised. All previously programmed commands will, however, be

retained in memory and can be used as they are if the last command

is not essential.

@ TRANSMIT indicator

This indicator flashes when remote control signals are sent.

@ LEARN selector switch

This can be set as follows:

LEARN:

This position is used for storing the codes of your remote control unit.

USE:

Set to this position after codes have been stored in the LEARN position.

{Set to this position when using memorized commands.)

SR RECALL:

Set to this position when transmitting Pioneer unified remote control

code signals (Marked on the remote control unit).

Set the TRANSMIT

MODE switch to AUDIO or VIDEO. In the AUX

mode, only the receiver remote control code is transmitted.

Operation Example

Using the remote control unit of your VCR to program the playback

command.

«It is recommended

that the name

of the key and its function

correspond. This is convenient when operating equipment.

1. Set the LEARN switch of the programmable remote control unit

to the LEARN

position and set the TRANSMIT

mode selector

switch to the VIDEO position.

* Programming is possible with the TRANSMIT mode selector

switch in any position, but VIDEO is used as an example.

2. Place the transmission sections of the programmable remote

control unit and the remote contro! of the VCR facing each other.

2 to 5.cm (1 to 2 inches)

——F

FETTTL

(1 to 2

inches).

Memorization will not be possible if they are too close.

3. Hold down the VCR PLAY (> ) key of the programmable remote

control unit until the LEARN indicator lights up, then release the

key.

4. Hold down the PLAY key of the VCR remote control unit.

5. Release the key of the VCR remote control unit after making sure

that the LEARN indicator has gone out on the Pioneer remote

control unit.

6. Set the LEARN selector switch of the programmable remote control

unit to the USE position,

* The previous code (Pioneer uniform remote control code or code

for other equipment) is erased and replaced by the new code.

7. Check that the program works.

* Try actual operation and make sure the unit works properly.

iy)

If the VCR does not operate when pressing the key, change angle,

position and distance between both remote control units and

repeat the programming procedure,

* When programming, make sure that the function indications (for

example,

, »r, Ml) on the other remote control unit and the

programmable remote control unit are the same. This will facilitate

operation.