Ariston AWD 120 Instrukcja naprawy - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja naprawy dla Spryskiwacz Ariston AWD 120. Ariston AWD 120 20 stron. Washer / washer-dryer combo

6. DRUM BOOT

• To remove the Drum Boot (Fig. 6-1) start by removing the Door Boot Spring (Fig. 6-2). The Door Boot Spring is located just under

the front lip of the Drum Boot. Using a small screwdriver, slide the screwdriver under the spring and carefully remove it from around

the seal. With the Door Boot Spring removed, unseat the Door Boot from the washer door opening (Fig. 6-3). As you remove the

Door Boot from the door opening note how the seal will be reseated on the door opening when replaced.

TECH NOTE: When reinstalling the Door Boot make sure that the Boot Tab is located at the11:00 O'clock position (Fig. 6-1).

Fig. 5-5

• With the Door Boot unseated from the door opening remove the Top Panel as described in Section 2. For easier access to the

Door Boot Clamp Bolt (Fig. 6-5) remove the Soap Dispenser Housing (Fig. 6-4) as described in Sections 3 and 8. Loosen the Door

Boot Clamp Bolt using an 8mm Nut Driver (Fig. 6-6), but do not loosen completely. With the Door Boot Clamp loose you can now

remove the Door Boot.

TECH TIP: When installing the new Door Boot leave the Boot Clamp loosely fit until you seat the Boot to the Outer Drum, then

tighten the Boot Clamp Bolt. Also make sure to water test the unit before replacing the Top Panel to ensure maximum

visibility for possible leaks.

REPAIR MANUAL

Fig. 6-1

Fig. 6-4

AW 120 / AW 122 / AW 125

AWD 120 / AWD 121 / AWD 129

Fig. 6-2

Fig. 6-5

Fig. 6-3

Fig. 6-6

Page: 7