Ariston LB6T Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Spryskiwacz Ariston LB6T. Ariston LB6T 13 stron. Ariston built-in washing machine user instruction lb6t, lb6tx

Drukuj stronę

Using the Drilling Template

Place the top edge of the drilling template so that it is flush

with the top edge of the panel, making sure that it is positioned

correctly and centered in the horizontal direction (use the dotted

lines on the edges to line the template up). Mark the points on

the panel for the four holes.

Use an appropriately sized router to mill the holes for the

two hinges, the rubber plug and the magnet.

Mounding the Parts onto the Wooden Panel

(Door)

Insert the hinges into the holes (the movable part of the

hinge must be positioned facing away from the panel) and

fasten them with the 4 type A screws.

Insert the magnet into the top hole on the opposite side

of the hinges and fasten it with the two type B screws.

Insert the rubber plug into the bottom hole.

The panel is now ready to be mounted onto the machine.

Mounting the Panel into the machine

Insert the nib of the hinge (indicated by the arrow in fig. 9)

into the hole for the hinge and push the panel towards the

front of the machine. Fasten the two hinges with the type

D screws.

Inserting the machine into the Cabinet

Push the machine into the opening, aligning it with the

cabinets (fig. 14).

Regulate the adjustable feet to raise the machine to the

appropriate height.

Technical characteristics

m odel LB 6 T - LB 6 TX

di m ensi ons w i dt h cm 59, 8

hei ght cm 82

dept h cm 53, 7

capaci t y 1 - 5 Kg

vol t age 220/ 230 Vol t 50 Hz

el ect r i cal

connect i ons

m axi m um abs or bed pow er 2300 W

w at er

m axi m um pr es s ur e 1 M Pa ( 10 bar )

connect i ons

m i ni m um pr es s ur e 0, 05 M Pa ( 0, 5 bar )

dr um capaci t y 42 l i t r es

spi nni ng speed up t o 600 r pm

Thi s appl i ance conf or m s w i t h t he f ol l ow i ng E. E. C.

di r ect i ves :

- 73/ 23/ EEC of 19/ 02/ 73 ( Low Vol t age) and

s ubs equent m odi f i cat i ons

- 89/ 336/ EEC of 03/ 05/ 89 ( El ect r om agnet i c

Com pat i bi l i t y) and s ubs equent m odi f i cat i ons

To adjust the position of the wooden panel in both the

vertical and horizontal directions, use the C and D screws,

as shown in fig. 15.

If the machine is installed at the end of a set of modular

cabinets, mount either one or both of the guides for the

base molding (as shown in fig. 16) with the type F screws.

Adjust them for depth based on the position of the base

molding, and, if necessary, fasten the base to the guides.

Fig. 14

Fig. 16

Control programs in compliance with IEC regulation 456:

Cotton program:

Turn knob A to the "program 2"setting;

Turn knob B to the "60°C" setting.

Fig. 15