Pioneer PD-M403 Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odtwarzacz CD Pioneer PD-M403. Pioneer PD-M403 16 stron. Multi-play compact disc player
Również dla Pioneer PD-M403: Instrukcja serwisowa (44 strony)

Drukuj stronę
Pioneer PD-M403 Instrukcja obsługi
TO PLAY ONLY DESIRED TRACKS/DISCS
Direct Program:
During normal playback or Magazine Hi-Lite Scan playback,
the track being played can be programmed.
1. Pressthe PROGRAM button to enterthe
program
mode.
2. To search for a desired track during normal play
back, it is possible to skip to succeeding tracks by
pressing the I<P< <1< or _
_
button.
Also, Magazine Hi-Lite Scanfunction can be used to move
from track to track through the disc.
3. If you wish to program thetrack currentlyplaying,
press the PROGRAM button while the track is
playing.
•
Direct programming is not possible during program
playback.
To check the program
contents
(PD-M423
only):
During program mode, set the player to stop mode and press
the CHECK button on the remote control unit. The program
contents will be displayed in the programmed
order.
•
After confirming
the last program step, the display will
show "0-00".
l PROGRAMMING
A PAUSE (PD-M423 only)
Inserting a pause in your program can be very useful when
carrying out recording.
Press the II button on the remote
control unit instead of entering a track number. "PA" appears
on the display panel.
•
For example, when recording on both sides of a cassette
tape, if you program a pause after the last track to be
recorded on the first side, program playback will pause at
that point to allow you to switch tape sides. To resume
program playback after the player enters pause mode,
press the II button on the remote control unit or I_/11button
on the front panel.
NOTE:
•
A pause can be programmed
only when the program
procedure is performed
under stop mode.
•
A pause cannot be programmed
at the beginning of a
program (P-01), nor can two pauses be programmed
one
after the other
•
A pause inserted in a program is counted as one step.
•
Ifa pause is programmedas
the last step of a program, the
player will not enter the pause mode.
To erase a program
(PD-M423
only):
During program mode, press the CLEAR button on the remote
control unit.
The last program step is erased and the contents
of the
previous program step are displayed.
NOTE:
Contents of a program can be erased during playback as well.
However tracks preceding the currently playing track cannot
be erased in this way.
To clear all of the program
contents:
A. During stop mode, press the • button.
B. When the magazine is ejected, the program contents will
be cleared.
To modify the program contents
(PD-M423 only):
1. During program
mode, set the player to stop
mode and press the CHECK button on the remote
control
unit so that the program
step to be
corrected appears on the display.
2. Enter the new disc number with the DISC NO.
buttons and then press the I_< _1_ or mH_
button so that the new track No. appears on the
display.
3. Press the PROGRAM button.
• Repeat steps 1 through 3 to change other tracks as
desired.
• If the I<1<_
or _
_1 button is not pressed within
2 seconds when correcting the track No., the displayed
track No. is automatically memorized.
13
<PRB1205>