Pioneer PDF904 Instrukcja obsługi - Strona 17

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odtwarzacz CD Pioneer PDF904. Pioneer PDF904 20 stron. File-type compact disc player
Również dla Pioneer PDF904: Instrukcja obsługi (22 strony)

Drukuj stronę

[TROUBLESHOOTNHG

Incorrect operations are often mistaken for trouble and malfunctions.

If you think that there is something

wrong with this component,

check

the points below. Sometimes

the trouble

may lie in another component.

Investigate

the other components

and electrical

appliances

being

used.

If the trouble cannot be rectified even after exercising

the checks listed below, ask your nearest PIONEER authorized service center or your

dealer to carry out repair work.

Symptom

The Rack is not opened when EJECT

button (&) is pressed.

When playback is started, it stops

immediately.

Pauses or stops during playback.

No sound

Probable cause

A disc in the desired Rack is being

played. ( The PLAY INDICATOR is blinking )

A disc is being searched

or 10 seconds have

not elapsed since playback finished.

Sound is distorted, noise is output.

The AC power plug is disconnected

from the

wall outlet.

The internal mechanism

is fixed with

transportation

screws.

Disc is inserted

the wrong way.

With certain discs,

loud noise is

produced, or play stops.

The picture

of the TV screen

fluctuating

or FM broadcast

has

noise interference.

Remote control will not function.

Smudges, etc., on the disc.

•

The selected disc has an electrostatic

charge.

Output

cables

are connected

incorrectly

loosely.

Incorrect

operation

of stereo

amplifier.

Pin plugs and/or amplifier terminals are dirty.

Player is in pause mode.

The disc is loaded with the label side leftward.

_ncorrect connections.

Pin plugs and/or amplifier terminals are dirty.

Interference

is being picked up from a TV set.

•

Disc has bad scratch or warp.

•

Disc is extremely

dirty.

Interference

is being picked up from the CD

player.

•

Dead batteries.

•

Too far from player or wrong angle.

Obstruction between player and remote control

unit.

Remedy

•

Close all the Racks and the front panels. Then stop

playing back a disc in the desired Rack, or start

playing back a disc in another Rack (for more than 10

seconds).

•

Close all the Racks and the front panels,

and wait for the Disc search to completely

finish or more than 10 seconds after finishing

playback.

•

Connect the AC power plug securely to the wall

outlet.

•

Remove the three transportation

screws. (See

page 4.)

•

Insert the disc correctly

with

the label side

rightward.

•

Clean the smudges

from the disc and then

play it again.

•

Carefully wipe the disc with the supplied Elec-

trostatic charge removal sheet (page 9).

Connect

properly.

Check the settings of amplifier switches

and

sound volume controls.

Clean away dirt.

Press • or II.

Reload the disc with the label side rightward.

•

Connect to amplifier's

AUX or CD terminals.

Do not connect to PHONO terminals.

•

Clean away dirt.

•

Switch OFF TV set, or move player away from

TV set.

•

Replace the disc.

Clean disc.

•

Turn off POWER of the player, or move the

player away from TV or tuner.

•

Replace batteries.

•

The distance between

remote control unit and

player should be no more than about 7 meters.

The operational

angle against the front panel

is within 30 ° from right or left end of player.

•

Relocate

remote

control

unit

or remove

obstruction.

Abnormal functioning of this unit may be caused by static electricity,

or other external interference.

To restore normal operation, turn the

power off and then on again, or unplug the AC power cord and then

plug it in again.