Pioneer PDR-509 Instrukcja obsługi - Strona 32

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odtwarzacz CD Pioneer PDR-509. Pioneer PDR-509 40 stron. Compact disc recorder
Również dla Pioneer PDR-509: Schematy serwisowe (23 strony), Instrukcja serwisowa (48 strony), Instrukcja serwisowa (23 strony), Instrukcja serwisowa (14 strony)

Drukuj stronę
Pioneer PDR-509 Instrukcja obsługi
Additional Recording Features

Monitoring a Source

If you have a set up like the figure below or like that on page 11, you can monitor the source without changing the input
function of the amplifier from the PDR–509 (you could also monitor through a pair of headphones connected to the
PDR–509's phones jack).
When recording, or in record-pause mode, the source signal is always available for monitoring from the analog outs of the
PDR–509. Even if you're not recording, you can still monitor—useful for cueing up a disc or tape for the next recording.
Source (CD, etc)
◊ÛB - .?/
INPUT
SELECTOR

Checking for Digital Copy Protection

Using the
MONITOR
Management System).
digital copies being made from the copy.
◊ÛB - .?/
INPUT
SELECTOR
32
Digital
or Analog
connection
1
2,3
2
MONITOR
TIME
3
button, you can also check whether or not a digital source is copy-protected with
allows you to make digital copies of original sources for your own use, but prevents further
SCMS
Original source
(CD, MD*, etc.)
*Not a digitally
copied MD!
2
1
2
MONITOR
TIME
Analog
PDR–509
connection
Start the source component playing.
Make sure that the input selector is set to the correct input.
Press MONITOR.
If the source is digital, the display indicates the input (
,or – – – – if the source is unknown). then the sampling rate (
DVD
or
). If the source is copy protected, the message
48
K
appears (see below for more on this), otherwise the display shows
(monitoring). If the source is analog, the display just shows
The source signal is fed through the analog outs of the unit, allowing you
to monitor.
To switch off monitoring, press MONITOR again.
CD–R/
Digital
CD-RW
copy
Digital
copy
Analog
copy
Start playing the digital source.
Make sure that the input selector is set to the correct digital input.
Press MONITOR.
The display indicates the input source (
rate, follwed by
CAN NOT COPY
If the display shows
(monitor), you can go ahead and record
MONI
normally.
Amp (input set to
PDR–509)
,
CD
MD
CAN NOT COPY
(Serial Copy
SCMS
CD–R/
CD-RW
,
, etc.) and its sampling
CD
MD
if the source is digital-copy protected.
,
,
,
DCC
DAT
,
32
K
44
K
MONI
.
MONI