Pioneer PDP-S56-LR Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System głośników Pioneer PDP-S56-LR. Pioneer PDP-S56-LR 33 stron.

Fit the hooks at the top of the speakers over the screws just

inserted, then align the holes in the hooks of the speakers

over the screw holes at the bottom of the Plasma Display

and use the M8 screws to screw loosely into place.

Screws (M8)

WARNING

Connecting the cords

Turn off the power of all connected units before connecting the cords.

Connect the display's SPEAKER R and L terminals with the

speakers' terminals using the included connection cords.

After connecting the speaker

terminals with the connection cords,

confirm that the cords are connected

at the terminal securely by tugging

on the cords. A loose connection may

cause sound dropouts or noise.

When the speakers are installed on the Plasma Display, do not move the unit by lifting up the

speakers. The Plasma Display could fall and cause injury.

Tighten the screws just inserted firmly into place

(4 locations).

*Tighten the screws while pushing the speakers lightly

against the Plasma Display. Check to be sure that all

four screws have been screwed firmly into place.

There is polarity

connection cord.

Connect each conductor to the correct terminal.

While holding the button of each speaker

t e r m i n a l , i n s e r t a c o n d u c t o r o f t h e

connection cord.

Cord Clamper

Remove the seal from the rear of the cord clampers,

attach the clampers in the desired position, and clamp the

cords into place.

E-3

with the conductor of each

Black

Red