Pioneer PDP-S59 Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System głośników Pioneer PDP-S59. Pioneer PDP-S59 44 stron. Speaker system
Również dla Pioneer PDP-S59: Instrukcja obsługi (5 strony)

Drukuj stronę

6. Tighten from below using the

supplied screws (three locations).

• Tighten the three screws in order 1, 2, 3 as shown in

the diagram (see page 6).

The screw hole at the rear surface of the speaker

mounting fitting is used when the plasma television is

installed with the table top stand. It is not used when

installed on the wall.

NOTE:

If after attaching the speaker its position needs to be

adjusted horizontally, first loosen the speaker mounting

screws, reposition and then tighten the screws again at

the appropriate position.

7. Bundling the cables (See procedure 6

on page 5).

IMPORTANT NOTICE – RECORD THE MODEL NUMBER AND SERIAL NUMBERS OF THIS EQUIPMENT BELOW.

MODEL NO.

SERIAL NO.

KEEP THESE NUMBERS FOR FUTURE USE.

If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used

electronic products in accordance with legislation that requires proper treatment, recovery and recycling.

Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to

designated collection facilities or to a retailer (if you purchase a similar new one).

For countries not mentioned above, please contact your local authorities for the correct method of disposal.

By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential

negative effects on the environment and human health.

THE NUMBERS ARE ON THE REAR.

CABINET MAINTENANCE

• Use a polishing cloth or dry cloth to wipe off dust and

dirt.

• When the cabinet is very dirty, wipe with a soft cloth

moistened with water-diluted cleanser; then wipe again

with a dry cloth. Do not use furniture wax or cleaners.

They may damage the surface of the cabinet.

• Never use thinner, benzine, insecticide sprays and other

chemicals on or near the cabinets, since these will corrode

the surfaces.

• When a chemical cloth is used, read the cautions for the

chemical cloth carefully.

SPECIFICATIONS

Cabinet ..................................................... Bass-reflex type

Used speaker (two-way system):

Woofer (for low tones) .......... 4.8 cm × 13 cm cone type

Tweeter (for high tones) ........... 2.5 cm semidome type

Nominal impedance ..................................................... 6 Ω

Frequency Range ................................ 60 Hz to 30 000 Hz

Sensitivity (1 m, 1 W) ............................................... 80 dB

Permissible input :

Max. input .............................................................. 18 W

Rated input .............................................................. 6 W

Crossover frequency ................................................ 3 kHz

External Dimensions

..................... 1 224 (W) mm × 77 (H) mm × 115 (D) mm

Weight ..................................................................... 2.9 kg

Accessory parts

.......................................................... Speaker cables × 2

........................................................................... Brackets

............................................... Screws (M5 × 10 mm) × 9

.............................................. Operating Instructions × 1

NOTE:

Specifications and design subject to possible modification

without notice, due to improvements.

English

Side × 2

Center × 1

D1-4-2-6-2_En

K058_A_En

Published by Pioneer Corporation.