Pioneer S-SP410 Instrukcja obsługi

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System głośników Pioneer S-SP410. Pioneer S-SP410 9 stron.

Drukuj stronę

S-SP410

S-SP410-K

English

This system is used in conjunction with the S-W90S subwoofer

BEFORE OPERATION

Thank you for buying this PIONEER product.

The S-SP410 system can be combined with the S-W90S to produce a 5.1

channels speaker system.

Read the Instruction Manual carefully before using this speaker system so that

you can operate it properly. After you have finished, put this manual away in a

safe place for future reference.

The rated impedance of this speaker system is 8 W. It must be connected to a

amplifier which accepts this type of load (miminum and maximum impedances

accepted by the amplifier are generally indicated near the loudspeaker outlets:

for example "4 W to 16 W" or "6 W to 16 W").

To guard against damage to this speaker system due to an electric power

overload, take the following precautions:

Do not supply more than the maximum permitted power to the speaker

system (see Specifications).

Any connection or switching on or off of part of the audio system (CD

player, tuner etc.) must be carried out after switching off the amplifier or at

least with the loudspeaker outlets disconnected (if the amplifier allows).

Interference caused by these operations will otherwise reach the speaker

and may damage the treble loudspeaker units.

When boosting particular frequencies using a graphic equaliser or bass

and treble correctors, make sure that you do not increase the amplifier

volume excessively, as the speaker will be overloaded more quickly.

Do not force a low-power amplifier to produce a high level of sound as

harmonic distortion increases rapidly in this situation and may pose a

danger to the treble speaker units.

Avoid touching the diaphragms and suspensions of speaker units as they are

fragile

The speaker units in this speaker system are magnetically shielded.

However, colours may blur if the speakers are positioned too close to a

television screen. If this happens, switch off the television and switch it

back on again after 15 to 30 minutes. If the problem persists, move the

speakers away from the television set.

INSTALLATION PRECAUTIONS

The S-SP410 system is composed of 1 centre, 2 front and 2 rear speakers.

For optimum sound reproduction of high frequencies, the treble speaker units

must be at the same height as the listener's ears.

For low frequencies, it is possible to increase the level of bass sounds by

positioning the speakers close to a wall (the maximum increase being obtained

for a position in a corner of the listening room).

Install the centre speaker above or below the TV so that the sound of the center

channel is localized at the tv screen.

Do not install these speakers close to an oven or heating appliance. Avoid

exposing them to direct sunlight. High temperature can distort the structure of the

enclosure and adversely affect the sound.

These speakers are heavy and fragile, therefore it is dangerous to install them

in an unstable position.

SPEAKER SYSTEM

ENCEINTE ACOUSTIQUE

LAUTSPRECHERSYSTEM

SISTEMA ALTOPARLANTE

LUIDSPREKERSYSTEEM

HÖGTALARSYSTEM

SISTEMA DE ALTAVOCES

SISTEMA DE ALTIFALANTES

CONNECTIONS

Switch off the amplifier power supply (OFF).

Connect the cables to the input terminals on the rear of the speaker: Connect

the neutral cable to the

terminal and the live cable to the

forget that the red input terminal has positive polarity and that the black input

terminal has negative polarity.

Connect the cables to the loudspeaker outlet terminals of the amplifier. Connect

the live cable to the

terminal and the neutral cable to the

1. Strip the insulation at the tip of

the cord and twist the strands

Centre Speaker

REMARKS :

Check that the cables are securely connected to the terminals. A loose

connection may cause not just intermittent or distorted sound but short-circuiting

and breakdown of the amplifier.

If the cables of one of the speakers have been connected with the wrong

polarities, you will find when listening to a stereo recording that bass sounds are

weakened and the stereo effect normally obtained between the two speakers

does not exist.

MAINTENANCE OF THE ENCLOSURE

Use a cloth to wipe away dust and dirt.

If the enclosure is very dirty, wipe with a soft cloth dipped in a neutral detergent

diluted five to six times with water, then wipe again with the dry cloth. Do not use

thinner, benzene, cleaning sprays or other chemical products on or near the

enclosures as the surfaces could be adversely affected.

SPECIFICATIONS

Speaker

Front - Rear speaker..............................Floor-standing type, enclosed

Centre............................................................Compact type, enclosed

System ...............................................................................2 ways, 5 speaker units

Speaker units Woofers ........................................ Cone speaker units, 50 mm x 4

Tweeter ..........................................................1 Dome type, 20 mm

Nominal Impedance ......................................................................................8 W

Frequency range : ................................................................ 150 Hz to 20 000 Hz

Sensitivity ....................................................................... 85 dB/W at 1 m distance

Maximum power .......................................................................................... 100 W

Dimensions

Front - Rear speaker............................ 210 mm (W) x 1050 mm (H) x 210 mm (D)

Centre speaker........................................... 370 mm (W) x 68 mm (H) x 48 mm (D)

Weight

Front - Rear speaker.......................................................................................... 3 kg

Centre speaker................................................................................................ 0.9 kg

Accessory parts

Instruction Manual ................................................................................................. 1

Warranty ................................................................................................................ 1

Cables.................................................................................................................... 5

REMARK : The specifications and design of this product are subject to change

without notice, in the interests of improvements.

INSTRUCTION MANUAL

MODE D'EMPLOI

BEDIENUNGSANLEITUNG

GUIDA PER L'USO

GEBRUIKSAANWIJZING

BRUKSANVISNING

GUIA DE OPERACIÓN

GUIA DE OPERAÇÃO

Published by Pioneer Corporation.

All reproduction and translation rights reserved.

Printed in China <PM-11003-10091-AFQ>

terminal. Do not

terminal.

2. Connect the common-side speaker

cord to the

terminal

3. Connect the hot-side speaker cord to

the

terminal

Tall-boy Speaker