Pioneer SP-C22 Instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System głośników Pioneer SP-C22. Pioneer SP-C22 17 stron. Andrew jones designed 5.1-channel speaker package
Również dla Pioneer SP-C22: Spesyfikacja (1 strony), Specyfikacje (2 strony)

Drukuj stronę

ENGLISH

www.pioneerelectronics.com

CONNECTING YOUR SYSTEM

IMPORTANT: Make sure all equipment is turned off before making any connections.

Correct wiring of your loudspeakers is essential for achieving the best sound quality. Be careful to ensure

proper polarity of connection. We recommend a minimum of 18 gauge for runs up to 25 feet, and thicker for

longer runs.

Most loudspeaker cable is coded to ease this task. Typically the ribbed or striped side is connected to the

positive (red) terminal. Make sure that the amplifier positive (red) terminal is connected to the loudspeaker

positive (red) terminal. Strip off ½" of insulation from the ends of the cable, twist the bare strands and insert

into the binding posts. Take care that no stray strands of wire short across between the terminals.

1: Strip the cover and twist the strands

Supporting Hooks

(Not Included)

Sufficiently

thick cord

(Not Included)

Safety catch

Negative

Wire going to negative

terminal of receiver

2: Connect each speaker cable (not included) to one set of the receiver's

speaker output terminals and the speaker input terminals. The red terminal

is the positive (+), and the black terminal is the negative (–). Make sure that

the receiver positive (red) terminal is connected to the speaker positive

Négative

(red) terminal.

INSTALLING AND REMOVING THE GRILL

Fil allant vers la borne

The front panel grill may be removed if desired. To remove, hold

négative du récepteur

the lower edge of the grill near the mounting points with both

hands and pull forward gently, away from the speaker. Repeat as

you work your way up the grill. To replace the grill on the speaker,

align the pegs on the grill with the holes in the speaker and

press in slowly.

Negativo

INSTALLING THE BASE TO THE SP-FS52

FLOORSTANDING SPEAKERS

Alambre que va al terminal

Included in the SP-FS52 carton are (1) base and (4) screws.

negativo del receptor

Attach the base to the bottom of the speaker using (4) screws,

as illustrated. (Screwdriver is not included.)

SECURING THE SP-FS52

FLOORSTANDING SPEAKERS

The SP-FS52 speaker comes with a safety catch pre-installed on the

back of the cabinet for securing to a wall to avoid tipping. Screw a

supporting hook (not included) into the wall behind the speaker. Pass

a thick cord (not included) around the supporting hook and through

the safety catch so that the speaker is stabilized (make sure to test

that it supports the weight of the speaker). After installing, make sure

the speaker is securely fixed.

CAUTION: The safety catch is not a mounting fixture and the speaker

should not be hung directly from the wall using this catch. Always use

a cord when stabilizing the speaker. Pioneer disclaims all responsibility

for any losses or damage resulting from improper assembly, installation,

insufficient strength of the installation materials, misuse, or natural

disasters. When placing this unit, ensure that it is firmly secured and

avoid areas where it may be likely to fall and cause injury in the event

of a natural disaster (such as an earthquake). Do not stand on the

speaker stand base to push or swing the speaker. The speaker may

fall and break, or someone may be injured. Play close attention to

children around the speaker.

Positive

Wire going to positive

terminal of receiver

Positive

Fil allant vers la borne

positive du récepteur

Positivo

Alambre que va al terminal

positivo del receptor