Pioneer SX-X360 Instrukcja obsługi - Strona 25

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System głośników Pioneer SX-X360. Pioneer SX-X360 35 stron. 5.1ch surround system

Drukuj stronę

Surround sound settings

• DRC OFF (default) – No dynamic range adjustment

(use when listening at higher volume)

• DRC MID – Mid setting

• DRC HIGH – Dynamic range is reduced (loud sounds

are reduced in volume while quieter sounds are

increased)

Press ENTER to exit.

Dual mono setting

Specifies how dual mono encoded Dolby Digital or DTS

soundtracks should be played. You can also use this

setting to switch the audio channel on DVD-RW discs

recorded with bilingual audio.

Press SETUP .

Use the

(cursor left/right) buttons to select

DUALMONO, then press ENTER .

Use

(cursor up/down) to select a setting.

Select one of the following:

• CH1 MONO (default) – Only channel 1 is played

• CH2 MONO – Only channel 2 is played

• CH1/CH2 – Both channels are played through the

front speakers

Press ENTER to exit.

Adjusting the channel levels using the

test tone

If you prefer, you can set the channel levels using a test

tone as a reference, rather than playing a source (see

Channel level setting on page 24). A test tone is played

through each speaker in turn, allowing you to adjust the

level as it plays.

Note that the channel level settings for stereo sources

are independent of the settings for surround sound

sources.

/TUNE

ENTER

MCACC

/TUNE

SURROUND

INPUT

CHANNEL

–

Press SURROUND to select the Auto listening

mode.

• If you want to set the channel levels for stereo (two

channel) playback, select the STEREO listening

mode.

Press TEST TONE .

The test tone is output from each speaker in turn.

While a test tone is playing, use the

up/down) buttons to adjust that channel level.

The aim is to adjust the levels so that you hear the test

tone at the same volume from each speaker. You can

adjust the level of each channel by ± 10 dB.

• You can adjust the overall volume of test tone output

using the VOLUME +/– buttons (this does not affect

the channel level settings).

• If the system is in Stereo or Virtual mode, you will not

be able to adjust the center or surround channels.

• Because of the ultra low frequencies the subwoofer

produces, it may sound quieter than it really is. We

suggest adjusting the subwoofer level while listening

to a source. See the method described in Channel

level setting on page 24.

When you're done, press ENTER to exit test tone

setup.

• If you use the Auto MCACC feature again, it will

overwrite the settings you have made here.

TIMER REC REC MODE

ONE TOUCH COPY

–

TEST TONE

VIDEO IN

SOUND

JUKE BOX

VOLUME

DISPLAY

–

RDS DISP

AXD7442

(cursor