Ariston LFC 3C33 WF X Codzienny podręcznik referencyjny - Strona 15

Przeglądaj online lub pobierz pdf Codzienny podręcznik referencyjny dla Zmywarka Ariston LFC 3C33 WF X. Ariston LFC 3C33 WF X 25 stron.

Drukuj stronę

CARE AND MAINTENANCE

CLEANING THE FILTER ASSEMBLY

Regularly clean the filter assembly so that the filters do not clog and that

the waste water flows away correctly.

Using dishwasher with clogged filters or foreign objects inside filtra-

tion system or sprayarms may cause unit malfunction resulting in lose

of performance, noisy work or higher resources usage.

The filter assembly consists of three filters which remove food residues

from the washing water and then recirculate the water.

The dishwasher must not be used without filters or if the filter is

loose.

At least once per month or after each 30 cycles, check the filter assembly

and if necessary clean it thoroughly under running water, using a non-

-metallic brush and following the instructions below:

1. Turn the cylindrical filter A in an anti-clockwise direction and pull

it out (Fig 1).

2. Remove the cup filter B by exerting a slight pressure on the side

flaps (Fig 2).

3. Slide out the stainless-steel plate filter C (Fig 3).

4. In case you find foreign objects (such as broken glass, porcelain,

bones, fruit seeds etc.) please remove them carefully.

5. Inspect the trap and remove any food residues. NEVER REMOVE

the wash-cycle pump protection (black detail) (Fig 4).

After cleaning the filters, re-place the filter assembly and fix it in

position correctly; this is essential for maintaining the efficient

operation of the dishwasher.

CLEANING THE WATER INLET HOSE

If the water hoses are new or have not been used for an extended

period of time, let the water run to make sure it is clear and free

of impurities before performing the necessary connections. If this

precaution is not taken, the water inlet could become blocked and da-

mage the dishwasher.

CLEANING THE SPRAY ARMS

On occasions, food residue may become encrusted onto the spray arms

and block the holes used to spray the water. It is therefore recommen-

ded that you check the arms from time to time and clean them with

a small non-metallic brush.

To remove the upper spray arm, turn the plastic locking ring in a

clockwise direction. The upper spray arm should be replaced so that

the side with the greater number of holes is facing upwards.

The lower spray arm may be removed by pulling it upwards.

WATER SOFTENING SYSTEM

Water softener automatically reduces water hardness, consequently

preventing scale buildup on heater, contributing also to better cleaning

efficiency.

This system regenerates itself with salt, therefore it is required

to refill salt container when empty.

Frequency of regeneration depends on water hardness level setting

- regeneration takes place once per 6 Eco cycles with water hardness

level set to 3.

Regeneration process starts in final rinse and finishes in drying phase,

before cycle ends.

• Single regeneration consumes: ~3.5L of water;

• Takes up to 5 additional minutes for the cycle;

• Consumes below 0.005kWh of energy.